Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

Comparative study by numerical simulation of two methods for automatic flow control in centrifugal pumps

International Journal of Power Electronics and Drive Systems · Vol. 13 No. 3 (2022) · hlm. 1365–1379

DOI
10.11591/ijpeds.v13.i3.pp1365-1379
ISSN
2722-256X, 2088-8694
Terbit
2022-09-01
Penerbit
Institute of Advanced Engineering and Science
Bahasa
eng
Lisensi
creativecommons.org/licenses/by-sa/4.0

Abstrak

Flow rate and pressure are variables of great interest in the process control industry, especially in pumping systems. With the help of modeling and simulation, it is possible to understand the operation of these systems prior to their construction, in addition to allowing their behavior to be analyzed in various operational scenarios and testing different control strategies. In this work, the hydraulic, mechanical, electrical and electronic models of the different components of the system are studied. Two study cases for automatic flow control are assembled, using Simscape library from MATLAB/Simulink R2019b. This study cases are: i) with a control valve and ii) with a variable speed drive. The simulations determined that both cases keep the flow constant in the face of pressure disturbances, with a good dynamic response. Case 2 consumes less power than case 1, between 24 and 64% less, especially at low flow rates. It also reduce unwanted mechanical and electrical problems due to sudden starts and stops. Case 2 produced harmonic pollution on both the grid and motor sides, which implies a potential risk for the motor and the electrical grid. Case 2 was experimentally validated, obtaining errors of less than 10%.

Kata kunci

Jaringan kolaborasi para penulis

14 penulis · 41 tautan kepenulisan bersama · 24 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Universidad Técnica de Manabí
  • Universidade Federal Rural de Pernambuco
  • Polytechnic José Antonio Echeverría
  • Universidad Central de Venezuela
  • Universidad Técnica Estatal de Quevedo
  • Universidad Laica Eloy Alfaro de Manabí
  • Universidad de la Costa
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
José Ricardo Núñez ÁlvarezUniversidad de la Costa2
Reinel Beltrán AguedoUniversidade Federal Rural de Pernambuco1
Ania Lussón CervantesUniversidade Federal Rural de Pernambuco1
Carlos E. Martínez OchoaAfiliasi tidak diketahui1
Ivón Oristela Benítez-GonzálezPolytechnic José Antonio Echeverría1
Ariel Omar Cepero DíazAfiliasi tidak diketahui1
Carlos Guillermo Miguélez MachadoPolytechnic José Antonio Echeverría1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) http://ijpeds.iaescore.com/index.php/IJPEDS/oai, pertama di-harvest 8 Nov 2026, terakhir terlihat 8 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">Comparative study by numerical simulation of two methods for automatic flow control in centrifugal pumps</dc:title>
	<dc:creator>Cedeno, Rogger José Andrade-</dc:creator>
	<dc:creator>Rodríguez, Jesús Alberto Pérez-</dc:creator>
	<dc:creator>Jaramillo, Carlos David Amaya-</dc:creator>
	<dc:creator>Borges, Ciaddy Gina Rodríguez-</dc:creator>
	<dc:creator>Cedeno, Endrickson Ramón Vera-</dc:creator>
	<dc:creator>Fernández, Luis Santiago Quiroz-</dc:creator>
	<dc:creator>Albuerne, Yolanda Eugenia Llosas-</dc:creator>
	<dc:subject xml:lang="en-US">Energy efficiency; Flow control; Modeling and simulation; Pumping systems; Variable speed drive</dc:subject>
	<dc:description xml:lang="en-US">Flow rate and pressure are variables of great interest in the process control industry, especially in pumping systems. With the help of modeling and simulation, it is possible to understand the operation of these systems prior to their construction, in addition to allowing their behavior to be analyzed in various operational scenarios and testing different control strategies. In this work, the hydraulic, mechanical, electrical and electronic models of the different components of the system are studied. Two study cases for automatic flow control are assembled, using Simscape library from MATLAB/Simulink R2019b. This study cases are: i) with a control valve and ii) with a variable speed drive. The simulations determined that both cases keep the flow constant in the face of pressure disturbances, with a good dynamic response. Case 2 consumes less power than case 1, between 24 and 64% less, especially at low flow rates. It also reduce unwanted mechanical and electrical problems due to sudden starts and stops. Case 2 produced harmonic pollution on both the grid and motor sides, which implies a potential risk for the motor and the electrical grid. Case 2 was experimentally validated, obtaining errors of less than 10%.</dc:description>
	<dc:publisher xml:lang="en-US">Institute of Advanced Engineering and Science</dc:publisher>
	<dc:contributor xml:lang="en-US"></dc:contributor>
	<dc:date>2022-09-01</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US"></dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://ijpeds.iaescore.com/index.php/IJPEDS/article/view/21957</dc:identifier>
	<dc:identifier>10.11591/ijpeds.v13.i3.pp1365-1379</dc:identifier>
	<dc:source xml:lang="en-US">International Journal of Power Electronics and Drive Systems (IJPEDS); Vol 13, No 3: September 2022; 1365-1379</dc:source>
	<dc:source>2722-256X</dc:source>
	<dc:source>2088-8694</dc:source>
	<dc:source>10.11591/ijpeds.v13.i3</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://ijpeds.iaescore.com/index.php/IJPEDS/article/view/21957/13887</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2022 Rogger José Andrade- Cedeno, Jesús Alberto Pérez- Rodríguez, Carlos David Amaya- Jaramillo, Ciaddy Gina Rodríguez- Borges, Endrickson Ramón Vera- Cedeno, Luis Santiago Quiroz- Fernández, Yolanda Eugenia Llosas- Albuerne</dc:rights>
	<dc:rights xml:lang="en-US">http://creativecommons.org/licenses/by-sa/4.0</dc:rights>
</oai_dc:dc>