Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

Assessment of the efficiency and performance of different PV system configurations under various fault conditions

International Journal of Power Electronics and Drive Systems · Vol. 16 No. 4 (2025) · hlm. 2744–2756

DOI
10.11591/ijpeds.v16.i4.pp2744-2756
ISSN
2722-256X, 2088-8694
Terbit
2025-12-01
Penerbit
Institute of Advanced Engineering and Science
Bahasa
eng
Lisensi
creativecommons.org/licenses/by-sa/4.0

Abstrak

Partial shadowing, bypass-diode issues, photovoltaic (PV) module deterioration, and wiring issues are examples of PV failures that have a substantial effect on power production and cause distinct peaks in a PV system's P-V curves. Various PV fault types have been used in the solar cell system in this work. Four types were used: open circuit, line to ground, cross-line to line, and intra-line to line. The impact of various PV system failure types on the system's performance was emphasized in this study. MATLAB is used to display the simulation results for the four approaches (series parallel (SP), total cross tied (TCT), honeycomb (HC), and bridge link (BL)) under various fault scenarios. The current-voltage (I-V) and power-voltage (P-V) curves are used to compare the results for each fault scenario. The open circuit fault between PV (7.8) in the first string and PV (18.19) in the fourth string resulted in a 40% decrease in the short-circuit current of the photovoltaic system compared to its normal value in the SP topology, while in the HC and BL topologies, the current value exceeded the allowable limit. This, in turn, had an impact on the (I-V) characteristics of this topology. The fault's impact was minimal and within the typical bounds of its (I-V) characteristics in the TCT topology.

Kata kunci

Jaringan kolaborasi para penulis

6 penulis · 6 tautan kepenulisan bersama

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • University of Mosul
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Ali Abbawi Mohammed AlabbawiAfiliasi tidak diketahui2
Omar Sharaf Al-Deen Al-YozbakyAfiliasi tidak diketahui1
Saif Kh Al-FarhanUniversity of Mosul1
Omar Sh. Al-YozbakyAfiliasi tidak diketahui1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) http://ijpeds.iaescore.com/index.php/IJPEDS/oai, pertama di-harvest 8 Nov 2026, terakhir terlihat 8 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">Assessment of the efficiency and performance of different PV system configurations under various fault conditions</dc:title>
	<dc:creator>Othman, Raghad Adeeb</dc:creator>
	<dc:creator>Al-Yozbaky, Omar Sharaf Al-Deen Yehya</dc:creator>
	<dc:subject xml:lang="en-US">fault diagnosis; ground fault; power voltage curve; PV configurations; PV panels fault analysis</dc:subject>
	<dc:description xml:lang="en-US">Partial shadowing, bypass-diode issues, photovoltaic (PV) module deterioration, and wiring issues are examples of PV failures that have a substantial effect on power production and cause distinct peaks in a PV system's P-V curves. Various PV fault types have been used in the solar cell system in this work. Four types were used: open circuit, line to ground, cross-line to line, and intra-line to line. The impact of various PV system failure types on the system's performance was emphasized in this study. MATLAB is used to display the simulation results for the four approaches (series parallel (SP), total cross tied (TCT), honeycomb (HC), and bridge link (BL)) under various fault scenarios. The current-voltage (I-V) and power-voltage (P-V) curves are used to compare the results for each fault scenario. The open circuit fault between PV (7.8) in the first string and PV (18.19) in the fourth string resulted in a 40% decrease in the short-circuit current of the photovoltaic system compared to its normal value in the SP topology, while in the HC and BL topologies, the current value exceeded the allowable limit. This, in turn, had an impact on the (I-V) characteristics of this topology. The fault's impact was minimal and within the typical bounds of its (I-V) characteristics in the TCT topology.</dc:description>
	<dc:publisher xml:lang="en-US">Institute of Advanced Engineering and Science</dc:publisher>
	<dc:contributor xml:lang="en-US"></dc:contributor>
	<dc:date>2025-12-01</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US"></dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://ijpeds.iaescore.com/index.php/IJPEDS/article/view/24121</dc:identifier>
	<dc:identifier>10.11591/ijpeds.v16.i4.pp2744-2756</dc:identifier>
	<dc:source xml:lang="en-US">International Journal of Power Electronics and Drive Systems (IJPEDS); Vol 16, No 4: December 2025; 2744-2756</dc:source>
	<dc:source>2722-256X</dc:source>
	<dc:source>2088-8694</dc:source>
	<dc:source>10.11591/ijpeds.v16.i4</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://ijpeds.iaescore.com/index.php/IJPEDS/article/view/24121/15115</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2025 Raghad Adeeb Othman, Omar Sharaf Al-Deen Al-Yozbaky</dc:rights>
	<dc:rights xml:lang="en-US">http://creativecommons.org/licenses/by-sa/4.0</dc:rights>
</oai_dc:dc>