Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

A new space vector modulation technique for quasi Z-source B4 inverter

International Journal of Power Electronics and Drive Systems · Vol. 11 No. 4 (2020) · hlm. 1890–1898

DOI
10.11591/ijpeds.v11.i4.pp1890-1898
ISSN
2722-256X, 2088-8694
Terbit
2020-12-01
Penerbit
Institute of Advanced Engineering and Science
Bahasa
eng
Lisensi
creativecommons.org/licenses/by-sa/4.0

Abstrak

A Quasi Z-Source (qZS) network has been utilized in a B4 inverter topology to provide voltage boosting effect by turning on the upper and lower switches simultaneously which is known as zero shoot-through states. However, the design of a qZS B4 inverter is not as straightforward as adding a qZS LC impedance network to the front-end of a B4 inverter. This is because there is no zero vectors available in a B4 inverter topology to insert the shoot through zero states, as in the case of a B6 inverter. This paper proposes a new Space Vector Modulation (SVM) technique for a qZS B4 inverter. Additional zero vectors have been appropriately added and distributed in the proposed SVM to avoid altering the existing volt-sec per switching cycle for the existing active vectors. The voltage vectors switching placement is carefully designed in order to enable the voltage boosting effect for this topology without altering the initial output voltage. In addition, an approach to compensate the DC-link voltage ripple has also been taken into consideration in its initial calculation to achieve balanced output voltage. The performance of the proposed modulation technique is verified using MATLAB/Simulink. It is shown that by using the proposed modulation technique, there is an overall improvement on the line to line output voltage where by it is able to produce balanced output voltages for the three-phase loads with or without boosting effect.

Jaringan kolaborasi para penulis

35 penulis · 136 tautan kepenulisan bersama · 43 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • University of Technology Malaysia
  • Aligarh Muslim University
  • Universitas Ahmad Dahlan
  • Al-Furat Al-Awsat Technical University
  • University of Maiduguri
  • Universiti Malaysia Pahang Al-Sultan Abdullah
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Tole SutiknoUniversitas Ahmad Dahlan6
Nik Rumzi Nik IdrisUniversity of Technology Malaysia6
Shahrin Md AyobUniversity of Technology Malaysia5
Razman AyopUniversity of Technology Malaysia4
M. Saad Bin ArifAligarh Muslim University3
Mohd Zaki DaudUniversity of Technology Malaysia2
Chee Wei TanUniversity of Technology Malaysia2
Ibrahim Mohd AlsofyaniUniversity of Technology Malaysia2
Aree WangsupphapholUniversity of Technology Malaysia2
Y.A. AlamriUniversity of Technology Malaysia2
Azizah Abdul RazakUniversity of Technology Malaysia2
Abobaker K. AbobakerUniversity of Technology Malaysia2
Nur Huda RamlanUniversiti Malaysia Pahang Al-Sultan Abdullah2
Yusra WahabAligarh Muslim University1
Md Ashraf Ali KhanAligarh Muslim University1
Kuber KuberAligarh Muslim University1
Awang JusohUniversity of Technology Malaysia1
S. KakarUniversity of Technology Malaysia1
Nik Din MuhamadUniversity of Technology Malaysia1
Saifullah KakarUniversity of Technology Malaysia1
Z. DaudAfiliasi tidak diketahui1
Dalya H. Al-MamooriUniversity of Technology Malaysia1
Ali A. Abdullah AlbakryAl-Furat Al-Awsat Technical University1
Kwan Yiew LauUniversity of Technology Malaysia1
Abba Lawan BukarUniversity of Maiduguri1
Syed Norazizul Syed NasirUniversity of Technology Malaysia1
N. H. RamlanAfiliasi tidak diketahui1
N. F. A. A. HafidzAfiliasi tidak diketahui1
Rozana AlikUniversity of Technology Malaysia1
Hairol JaffarUniversity of Technology Malaysia1
Jasrul Jamani JamianUniversity of Technology Malaysia1
Hazlina SelamatUniversity of Technology Malaysia1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) http://ijpeds.iaescore.com/index.php/IJPEDS/oai, pertama di-harvest 8 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">A new space vector modulation technique for quasi Z-source B4 inverter</dc:title>
	<dc:creator>Mustafar, Izni</dc:creator>
	<dc:creator>Azli, Naziha A.</dc:creator>
	<dc:creator>Nordin, Norjulia M.</dc:creator>
	<dc:description xml:lang="en-US">A Quasi Z-Source (qZS) network has been utilized in a B4 inverter topology to provide voltage boosting effect by turning on the upper and lower switches simultaneously which is known as zero shoot-through states. However, the design of a qZS B4 inverter is not as straightforward as adding a qZS LC impedance network to the front-end of a B4 inverter. This is because there is no zero vectors available in a B4 inverter topology to insert the shoot through zero states, as in the case of a B6 inverter. This paper proposes a new Space Vector Modulation (SVM) technique for a qZS B4 inverter. Additional zero vectors have been appropriately added and distributed in the proposed SVM to avoid altering the existing volt-sec per switching cycle for the existing active vectors. The voltage vectors switching placement is carefully designed in order to enable the voltage boosting effect for this topology without altering the initial output voltage. In addition, an approach to compensate the DC-link voltage ripple has also been taken into consideration in its initial calculation to achieve balanced output voltage. The performance of the proposed modulation technique is verified using MATLAB/Simulink. It is shown that by using the proposed modulation technique, there is an overall improvement on the line to line output voltage where by it is able to produce balanced output voltages for the three-phase loads with or without boosting effect.</dc:description>
	<dc:publisher xml:lang="en-US">Institute of Advanced Engineering and Science</dc:publisher>
	<dc:contributor xml:lang="en-US">Universiti Teknologi Malaysia</dc:contributor>
	<dc:date>2020-12-01</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US"></dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://ijpeds.iaescore.com/index.php/IJPEDS/article/view/20396</dc:identifier>
	<dc:identifier>10.11591/ijpeds.v11.i4.pp1890-1898</dc:identifier>
	<dc:source xml:lang="en-US">International Journal of Power Electronics and Drive Systems (IJPEDS); Vol 11, No 4: December 2020; 1890-1898</dc:source>
	<dc:source>2722-256X</dc:source>
	<dc:source>2088-8694</dc:source>
	<dc:source>10.11591/ijpeds.v11.i4</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://ijpeds.iaescore.com/index.php/IJPEDS/article/view/20396/13269</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2020 Izni Mustafar, Naziha A. Azli, Norjulia M. Nordin</dc:rights>
	<dc:rights xml:lang="en-US">http://creativecommons.org/licenses/by-sa/4.0</dc:rights>
</oai_dc:dc>