Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

A Novel High Speed FPGA Architecture for FIR Filter Design

International Journal of Reconfigurable and Embedded Systems (IJRES) · Vol. 1 No. 1 (2012) · hlm. 1–10

DOI
10.11591/ijres.v1.i1.pp1-10
ISSN
2722-2608, 2089-4864
Terbit
2012-03-01
Penerbit
Institute of Advanced Engineering and Science
Bahasa
eng
Lisensi
creativecommons.org/licenses/by-sa/4.0

Abstrak

This paper presents the details of hardware implementation of linear phase FIR filter using merged MAC architecture. Speed of convolution operation of FIR filter is improved using merged MAC architecture. By exploiting the reduced complexity made possible by the use of sparse powers of two partial products terms coefficients, an FIR filter tap can be implemented with 2B full adders, and 2B latches, where B is intermediate wordlegnth. Word and bit level parallelism allows high sampling rates, limited only by the full adder delay. The proposed architecture is based on binary tree constructed using modified 4:2 and 5:2 compressor circuits. Increasing the speed of operation is achieved by using higher modified compressors in critical path. Our objective of work is, to increase the speed of multiplication and accumulation operation by minimizing the number of combinational gates using higher n: 2 compressors, which is required more for Array multiplier at the time of implementation of array architecture. This novel architecture allows the implementation of high sampling rate filters of significant length on FPGA Spartan-3 device (XC3S400 PQ-208). The simulation result shows convolution output of digital FIR filter which is done using Questa Sim 6.4c Mentor Graphics tool. The experimental test of the proposed digital FIR filter is done using Spartan-3 device (XC3S400 PQ-208)

Jaringan kolaborasi para penulis

10 penulis · 13 tautan kepenulisan bersama · 3 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Shivaji University
  • Bharati Vidyapeeth (Deemed to be University)
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Sanjay Bandu PatilAfiliasi tidak diketahui2
Babasaheb G. PatilAfiliasi tidak diketahui1
Shaila SubbaramanAfiliasi tidak diketahui1
Vishwanath R. UdupAfiliasi tidak diketahui1
Vishwanath R. UdupiAfiliasi tidak diketahui1
Sanjay B. PatilAfiliasi tidak diketahui1
Jayamala Kumar PatilShivaji University1
Ramesh T. PatilShivaji University1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) http://ijres.iaescore.com/index.php/IJRES/oai, pertama di-harvest 8 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">A Novel High Speed FPGA Architecture for FIR Filter Design</dc:title>
	<dc:creator>B. Jadhav, Sachin</dc:creator>
	<dc:creator>Mane, Nikhil Niwas</dc:creator>
	<dc:description xml:lang="en-US"> This paper presents the details of hardware implementation of linear phase FIR filter using merged MAC architecture. Speed of convolution operation of FIR filter is improved using merged MAC architecture. By exploiting the reduced complexity made possible by the use of sparse powers of two partial products terms coefficients, an FIR filter tap can be implemented with 2B full adders, and 2B latches, where B is intermediate wordlegnth. Word and bit level parallelism allows high sampling rates, limited only by the full adder delay. The proposed architecture is based on binary tree constructed using modified 4:2 and 5:2 compressor circuits. Increasing the speed of operation is achieved by using higher modified compressors in critical path. Our objective of work is, to increase the speed of multiplication and accumulation operation by minimizing the number of combinational gates using higher n: 2 compressors, which is required more for Array multiplier at the time of implementation of array architecture. This novel architecture allows the implementation of high sampling rate filters of significant length on FPGA Spartan-3 device (XC3S400 PQ-208). The simulation result shows convolution output of digital FIR filter which is done using Questa Sim 6.4c Mentor Graphics tool. The experimental test of the proposed digital FIR filter is done using Spartan-3 device (XC3S400 PQ-208)</dc:description>
	<dc:publisher xml:lang="en-US">Institute of Advanced Engineering and Science</dc:publisher>
	<dc:date>2012-03-01</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US"></dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://ijres.iaescore.com/index.php/IJRES/article/view/1180</dc:identifier>
	<dc:identifier>10.11591/ijres.v1.i1.pp1-10</dc:identifier>
	<dc:source xml:lang="en-US">International Journal of Reconfigurable and Embedded Systems (IJRES); Vol 1, No 1: March 2012; 1-10</dc:source>
	<dc:source>2722-2608</dc:source>
	<dc:source>2089-4864</dc:source>
	<dc:source>10.11591/ijres.v1.i1</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://ijres.iaescore.com/index.php/IJRES/article/view/1180/pdf</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2012 Institute of Advanced Engineering and Science</dc:rights>
	<dc:rights xml:lang="en-US">http://creativecommons.org/licenses/by-sa/4.0</dc:rights>
</oai_dc:dc>