Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

Investigation of Process Parameters Influence on Municipal Solid Waste Gasification with CO2 Capture via Process Simulation Approach

International Journal of Renewable Energy Development : JRED · Vol. 10 No. 1 (2021) · hlm. 1–10

DOI
10.14710/ijred.2021.31982
ISSN
2252-4940
Terbit
2021-02-01
Penerbit
Center of Biomass & Renewable Energy (CBIORE)
Bahasa
eng
Lisensi
creativecommons.org/licenses/by-sa/4.0

Abstrak

Integration of gasification with CO2 capture using CaO sorbent is proposed as an alternative treatment to convert municipal solid waste (MSW) into energy. Aspen Plus process simulator was employed to study the process. Two models were built to represent the non-sorbent and the sorbent-enabled MSW gasification. The model validation against available experimental data shows high accuracy of the simulation result. The effect of CO2 capture using CaO sorbent on the syngas composition and lower heating value (LHV) was observed by comparing the two models, and sensitivity analysis was performed on both models. Several process parameters affecting the syngas composition and LHV were investigated, including CaO/MSW ratio, temperature, equivalence ratio, and steam/MSW ratio. The addition of CaO sorbent for CO2 capture was found to successfully reduce the CO2 content in the syngas, increase the H2 composition, and improve the syngas LHV at the temperature below 750 oC. The maximum H2 composition of 56.67% was obtained from the sorbent-enabled gasification. It was found that increasing equivalence ratio leads to a higher H2 concentration and syngas LHV. Raising steam/MSW ratio also increases the H2 production, but also reduces the LHV of the syngas. Observation of the temperature effect found the highest H2 production at 650 oC for both non-sorbent and sorbent-enabled gasification.

Kata kunci

Jaringan kolaborasi para penulis

7 penulis · 12 tautan kepenulisan bersama · 6 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Islamic University of Indonesia
  • Institut Teknologi Indonesia
  • Badan Pengkajian dan Penerapan Teknologi
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Rizqon FajarBadan Pengkajian dan Penerapan Teknologi1
Joelianingsih JoelianingsihInstitut Teknologi Indonesia1
Pangeran PutraInstitut Teknologi Indonesia1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://ijred.cbiore.id/index.php/ijred/oai, pertama di-harvest 8 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">Investigation of Process Parameters Influence on Municipal Solid Waste Gasification with CO2 Capture via Process Simulation Approach</dc:title>
	<dc:creator>Rahma, Fadilla Noor</dc:creator>
	<dc:creator>Tamzysi, Cholila</dc:creator>
	<dc:creator>Hidayat, Arif</dc:creator>
	<dc:creator>Adnan, Muflih Arisa</dc:creator>
	<dc:subject xml:lang="en-US">CaO sorption; CO2 capture; gasification; municipal solid waste; syngas</dc:subject>
	<dc:description xml:lang="en-US">Integration of gasification with CO2 capture using CaO sorbent is proposed as an alternative treatment to convert municipal solid waste (MSW) into energy. Aspen Plus process simulator was employed to study the process. Two models were built to represent the non-sorbent and the sorbent-enabled MSW gasification. The model validation against available experimental data shows high accuracy of the simulation result. The effect of CO2 capture using CaO sorbent on the syngas composition and lower heating value (LHV) was observed by comparing the two models, and sensitivity analysis was performed on both models. Several process parameters affecting the syngas composition and LHV were investigated, including CaO/MSW ratio, temperature, equivalence ratio, and steam/MSW ratio. The addition of CaO sorbent for CO2 capture was found to successfully reduce the CO2 content in the syngas, increase the H2 composition, and improve the syngas LHV at the temperature below 750 oC. The maximum H2 composition of 56.67% was obtained from the sorbent-enabled gasification. It was found that increasing equivalence ratio leads to a higher H2 concentration and syngas LHV. Raising steam/MSW ratio also increases the H2 production, but also reduces the LHV of the syngas. Observation of the temperature effect found the highest H2 production at 650 oC for both non-sorbent and sorbent-enabled gasification. </dc:description>
	<dc:publisher xml:lang="en-US">Center of Biomass &amp; Renewable Energy (CBIORE)</dc:publisher>
	<dc:date>2021-02-01</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US"></dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://ijred.cbiore.id/index.php/ijred/article/view/31982</dc:identifier>
	<dc:identifier>10.14710/ijred.2021.31982</dc:identifier>
	<dc:source xml:lang="en-US">International Journal of Renewable Energy Development; Vol 10, No 1 (2021): February 2021; 1-10</dc:source>
	<dc:source>2252-4940</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://ijred.cbiore.id/index.php/ijred/article/view/31982/pdf</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2021 The Authors. Published by Centre of Biomass and Renewable Energy (CBIORE)</dc:rights>
	<dc:rights xml:lang="en-US">https://creativecommons.org/licenses/by-sa/4.0</dc:rights>
</oai_dc:dc>