Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

A dry cold sintering to Ta doped-lithium lanthanum zirconate solid electrolyte for all-solid-state lithium metal battery

International Journal of Renewable Energy Development : JRED · Vol. 13 No. 5 (2024) · hlm. 952–959

DOI
10.61435/ijred.2024.60351
ISSN
2252-4940
Terbit
2024-09-01
Penerbit
Center of Biomass & Renewable Energy (CBIORE)
Bahasa
eng
Lisensi
creativecommons.org/licenses/by-sa/4.0

Abstrak

Solid electrolyte is the essential part in all-solid-state battery (ASSB), in which the sintering step is vital to get a dense and high ionic conductivity. However, Li-loss frequently occurs at a high temperature, causing ionic conductivity to drop. This research investigated a dry-cold sintering process (dry-CSP) to Ta doped-LLZO (LLZTO), in which the LLZTO powder was pressed by cold isostatic pressing (CIP) at 40 MPa without solvent addition and then heated at 300oC for 2h. XRD analysis found that LLZTO300C40P remains crystallized in a single cubic with ionic conductivity of (3.02 0.53) x 10-5 Scm-1, which is higher than another result in Al doped-LLZO by CSP uniaxial pressing and with moistened-solvent (wet-CSP). The feasibility was tested by preparing a coin cell with a LiCoO2 cathode and Li metal anode. Cyclic voltammogram of the LCO-LLZTO300C40P-Li ASSB provides a high current density representing a higher electrochemical reaction rate inside the full cell. The battery ran well with an initial charging capacity of 88 mAh/g, and a discharge capacity of 50 mAh/g, providing 56.8 % Coulombic Efficiency. An interface engineering between electrode-solid electrolyte is essential to develop the ASSB performance.

Kata kunci

Jaringan kolaborasi para penulis

40 penulis · 134 tautan kepenulisan bersama · 48 lintas organisasi · menampilkan 40 yang paling banyak terhubung

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Sebelas Maret University
  • Pertamina (Indonesia)
  • Universitas Gadjah Mada
  • Universitas Pertamina
  • Institute for Materials Chemistry and Engineering, Kyushu University
  • Gyeongsang National University
  • National Taiwan University of Science and Technology
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Yuniawan HidayatSebelas Maret University6
Khoirina Dwi NugrahaningtyasSebelas Maret University5
Eddy HeraldySebelas Maret University4
Agung Tri WijayantaSebelas Maret University3
Viona NataliaSebelas Maret University2
Witri Wahyu LestariSebelas Maret University2
Nur Lathifah AiniSebelas Maret University2
Qanita RidwanSebelas Maret University2
Ita PermadaniSebelas Maret University1
Dhini A. PhasaSebelas Maret University1
Andini PratiwiSebelas Maret University1
Sayekti WahyuningsihSebelas Maret University1
Dian IriantiSebelas Maret University1
Siti Nur RondiyahSebelas Maret University1
Koji NakabayashiInstitute for Materials Chemistry and Engineering, Kyushu University1
Jin MiyawakiInstitute for Materials Chemistry and Engineering, Kyushu University1
Rini WulandariSebelas Maret University1
Irvina M. MurniSebelas Maret University1
Moedjijono MoedjijonoSebelas Maret University1
TriyonoAfiliasi tidak diketahui1
Wega TrisunaryantiUniversitas Gadjah Mada1
Dyah Ayu FatmawatiUniversitas Gadjah Mada1
Uswatul ChasanahUniversitas Gadjah Mada1
Iman SantosoUniversitas Gadjah Mada1
Fadila Arum RamadhaniAfiliasi tidak diketahui1
Eduardus Budi NursantoUniversitas Pertamina1
Nur Layli AmanahNational Taiwan University of Science and Technology1
Alsello Diveni ManuputtyUniversitas Pertamina1
Dita FloresyonaUniversitas Pertamina1
Agung NugrohoUniversitas Pertamina1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://ijred.cbiore.id/index.php/ijred/oai, pertama di-harvest 8 Nov 2026, terakhir terlihat 8 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">A dry cold sintering to Ta doped-lithium lanthanum zirconate solid electrolyte for all-solid-state lithium metal battery</dc:title>
	<dc:creator>Rahmawati, Fitria</dc:creator>
	<dc:creator>Alaih, Imam Shofid</dc:creator>
	<dc:creator>Rosalin, Azka W</dc:creator>
	<dc:creator>Nurcahyo, I F</dc:creator>
	<dc:creator>Nursukatmo, Hartoto</dc:creator>
	<dc:creator>Nilasary, Hanida</dc:creator>
	<dc:creator>Oktaviano, Haryo S.</dc:creator>
	<dc:creator>Raihan, Edo</dc:creator>
	<dc:creator>Muzayanha, Soraya U.</dc:creator>
	<dc:creator>Handaka, Muhammad F. A.</dc:creator>
	<dc:subject xml:lang="en-US">Dry cold sintering; lithium lanthanum zirconate; Tantalum doped-LLZO; solid electrolyte; all solid state-lithium- ion battery.</dc:subject>
	<dc:description xml:lang="en-US">Solid electrolyte is the essential part in all-solid-state battery (ASSB), in which the sintering step is vital to get a dense and high ionic conductivity. However, Li-loss frequently occurs at a high temperature, causing ionic conductivity to drop. This research investigated a dry-cold sintering process (dry-CSP) to Ta doped-LLZO (LLZTO), in which the LLZTO powder was pressed by cold isostatic pressing (CIP) at 40 MPa without solvent addition and then heated at 300oC for 2h. XRD analysis found that LLZTO300C40P remains crystallized in a single cubic with ionic conductivity of (3.02 0.53) x 10-5 Scm-1, which is higher than another result in Al doped-LLZO by CSP uniaxial pressing and with moistened-solvent (wet-CSP). The feasibility was tested by preparing a coin cell with a LiCoO2 cathode and Li metal anode. Cyclic voltammogram of the LCO-LLZTO300C40P-Li ASSB provides a high current density representing a higher electrochemical reaction rate inside the full cell. The battery ran well with an initial charging capacity of 88 mAh/g, and a discharge capacity of 50 mAh/g, providing 56.8 % Coulombic Efficiency. An interface engineering between electrode-solid electrolyte is essential to develop the ASSB performance.</dc:description>
	<dc:publisher xml:lang="en-US">Center of Biomass &amp; Renewable Energy (CBIORE)</dc:publisher>
	<dc:date>2024-09-01</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US"></dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://ijred.cbiore.id/index.php/ijred/article/view/60351</dc:identifier>
	<dc:identifier>10.61435/ijred.2024.60351</dc:identifier>
	<dc:source xml:lang="en-US">International Journal of Renewable Energy Development; Vol 13, No 5 (2024): September 2024; 952-959</dc:source>
	<dc:source>2252-4940</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://ijred.cbiore.id/index.php/ijred/article/view/60351/pdf</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2024 The Author(s). Published by Centre of Biomass and Renewable Energy (CBIORE)</dc:rights>
	<dc:rights xml:lang="en-US">https://creativecommons.org/licenses/by-sa/4.0</dc:rights>
</oai_dc:dc>