Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

An innovative air-cooling system for efficiency improvement of retrofitted rooftop photovoltaic module using cross-flow fan

International Journal of Renewable Energy Development : JRED · Vol. 13 No. 2 (2024) · hlm. 223–234

DOI
10.61435/ijred.2024.60068
ISSN
2252-4940
Terbit
2024-03-01
Penerbit
Center of Biomass & Renewable Energy (CBIORE)
Bahasa
eng
Lisensi
creativecommons.org/licenses/by-sa/4.0

Abstrak

This study presents an innovative air-cooling photovoltaic (PV)system using cross-flow fan with speed regulation to optimize performance of rooftop PVsystem in tropical climates like Malaysia. Air passed through the impeller enters perpendicularly to the motor shaft, deflected by the fan blades and evacuated, allowing the fan to operate at its most efficient operating point. The airflow provided within the rear of the PV modules and the roof surface blow out the trapped hot air. Changes in the module temperature (Tcell) are detected and the fan speed are adjusted accordingly to the PWM. This method was tested for 12 hours continuously from 7:00 am on the existing PV system at German Malaysian Institute (GMI) Bangi. The highest Tcell achieved 72.88 °C and 55.75°C without and with air-cooling system with average power 210.22 W and 246.67 W per peak sun factor (PSF) respectively. There was a 17.34% increase in average power with a 13.18% in average net output power and achieved 6.68% energy efficiency using the proposed cooling system. Tcell increases more swiftly and reaches higher temperatures in the absence of a cooling system, whereas Tcell increases more slowly and at lower temperatures when a cooling system is present. The projected system's power rating was 6.48 W, which is 2.6% per PV module, and it really attained 6.32 W, which is 2.53% per PV module, while total energy consumption by the fan was 51.89 Wh per day, which is only 3.89% per PV module.

Kata kunci

Jaringan kolaborasi para penulis

23 penulis · 59 tautan kepenulisan bersama · 16 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Universiti Putra Malaysia
  • Universiti Teknikal Malaysia Melaka
  • German-Malaysian Institute
  • Tun Hussein Onn University of Malaysia
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Mohammad Lutfi OthmanUniversiti Putra Malaysia2
Mohammad Lufti OthmanAfiliasi tidak diketahui1
Norhafiz AzisAfiliasi tidak diketahui1
Azniza AhmadUniversiti Putra Malaysia1
Kurreemun Khudsiya Bibi ZainabUniversiti Putra Malaysia1
Nur AyuniUniversiti Putra Malaysia1
Norman MariunUniversiti Putra Malaysia1
Syed Zahurul IslamTun Hussein Onn University of Malaysia1
Auzani JidinUniversiti Teknikal Malaysia Melaka1
Musa Yusup LadaUniversiti Teknikal Malaysia Melaka1
Mohd Amran Mohd RadziUniversiti Putra Malaysia1
Jasronita JasniUniversiti Putra Malaysia1
Syahrul Hisham MohamadUniversiti Teknikal Malaysia Melaka1
Osaj EmmanuelAfiliasi tidak diketahui1
Elhadi Emhemed AkerUniversiti Putra Malaysia1
Ishak b. ArisUniversiti Putra Malaysia1
Noor Izzri Abdul WahabUniversiti Putra Malaysia1
Ali SalmiatonUniversiti Putra Malaysia1
Chee Hoe NgAfiliasi tidak diketahui1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://ijred.cbiore.id/index.php/ijred/oai, pertama di-harvest 8 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">An innovative air-cooling system for efficiency improvement of retrofitted rooftop photovoltaic module using cross-flow fan</dc:title>
	<dc:creator>Mustafa, Rozita</dc:creator>
	<dc:creator>Mohd Radzi, Mohd Amran Bin</dc:creator>
	<dc:creator>Hizam, Hashim Bin</dc:creator>
	<dc:creator>Che Soh, Azura</dc:creator>
	<dc:subject xml:lang="en-US">uniform air-cooling; cross-flow fan; PV module temperature; cooling technique; photovoltaic</dc:subject>
	<dc:description xml:lang="en-US">This study presents an innovative air-cooling photovoltaic (PV)system using cross-flow fan with speed regulation to optimize performance of rooftop PVsystem in tropical climates like Malaysia. Air passed through the impeller enters perpendicularly to the motor shaft, deflected by the fan blades and evacuated, allowing the fan to operate at its most efficient operating point. The airflow provided within the rear of the PV modules and the roof surface blow out the trapped hot air. Changes in the  module temperature (Tcell) are detected and the fan speed are adjusted accordingly to the PWM. This method was tested for 12 hours continuously from 7:00 am on the existing PV system at German Malaysian Institute (GMI) Bangi. The highest Tcell achieved 72.88 °C and 55.75°C without and with air-cooling system with average power 210.22 W and 246.67 W per peak sun factor (PSF) respectively. There was a 17.34% increase in average power with a 13.18% in average net output power and achieved 6.68% energy efficiency using the proposed cooling system. Tcell increases more swiftly and reaches higher temperatures in the absence of a cooling system, whereas Tcell increases more slowly and at lower temperatures when a cooling system is present. The projected system's power rating was 6.48 W, which is 2.6% per PV module, and it really attained 6.32 W, which is 2.53% per PV module, while total energy consumption by the fan was 51.89 Wh per day, which is only 3.89% per PV module.</dc:description>
	<dc:publisher xml:lang="en-US">Center of Biomass &amp; Renewable Energy (CBIORE)</dc:publisher>
	<dc:date>2024-03-01</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US"></dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://ijred.cbiore.id/index.php/ijred/article/view/60068</dc:identifier>
	<dc:identifier>10.61435/ijred.2024.60068</dc:identifier>
	<dc:source xml:lang="en-US">International Journal of Renewable Energy Development; Vol 13, No 2 (2024): March 2024; 223-234</dc:source>
	<dc:source>2252-4940</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://ijred.cbiore.id/index.php/ijred/article/view/60068/pdf</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2024 The Author(s). Published by Centre of Biomass and Renewable Energy (CBIORE)</dc:rights>
	<dc:rights xml:lang="en-US">https://creativecommons.org/licenses/by-sa/4.0</dc:rights>
</oai_dc:dc>