Melola Discovery

← Melola Discovery

Jurnal SINTA 1

Seismic Performance of RC Hollow Rectangular Bridge Piers Retrofitted by Concrete Jacketing Considering the Initial Load and Interface Slip

Journal of Engineering and Technological Sciences · Vol. 52 No. 3 (2020) · hlm. 343–369

DOI
10.5614/j.eng.technol.sci.2020.52.3.4
ISSN
2338-5502, 2337-5779
Terbit
2020-06-25
Penerbit
Directorate for Research and Community Services, Institut Teknologi Bandung
Bahasa
eng

Abstrak

In design practice, the assumptions that are used in retrofitting concrete structural elements often ignore the initial load and the interface slip on the contact surfaces between the old and the new concrete. The concrete structural elements that are loaded by the existing gravity load cause initial strain on the existing cross-section before jacketing is applied, while the interface does not act in a fully composite manner. In this study, a seismic performance evaluation using pushover analysis was performed of a damaged reinforced concrete bridge pier retrofitted with concrete jacketing, where the plastic hinge of the retrofitted elements was modeled by considering both parameters. The results showed that concrete jacketing could increase the capacity of the bridge structure. It was also found from the numerical result that the performance level of the bridge considering the initial load compared to the monolithic approach gave the same result since the initial load did not significantly affect the cross-sectional ultimate capacity. The difference between the ultimate capacity values computed by the two models was less than 7%. It was also shown that the interface slip had a significant effect with a slip coefficient smaller than 0.5.

Kata kunci

Jaringan kolaborasi para penulis

13 penulis · 28 tautan kepenulisan bersama · 8 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Bandung Institute of Technology
  • Direktorat Jenderal Bina Marga
  • Maranatha Christian University
  • Ministerio de Transportes, Movilidad y Agenda Urbana
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Yurisman YurismanBandung Institute of Technology1
Bambang BudionoBandung Institute of Technology1
Muslinang MoestopoBandung Institute of Technology1
Anang KristiantoMaranatha Christian University1
Iswandi ImranBandung Institute of Technology1
Ivindra PaneBandung Institute of Technology1
Tito AdibaskoroBandung Institute of Technology1
Indra Djati SidiBandung Institute of Technology1
Widi NugrahaMinisterio de Transportes, Movilidad y Agenda Urbana1
Ediansjah ZulkifliBandung Institute of Technology1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://journals.itb.ac.id/index.php/jets/oai, pertama di-harvest 9 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">Seismic Performance of RC Hollow Rectangular Bridge Piers Retrofitted by Concrete Jacketing Considering the Initial Load and Interface Slip</dc:title>
	<dc:creator>Suarjana, Made</dc:creator>
	<dc:creator>Octora, Daniel Dixon</dc:creator>
	<dc:creator>Riyansyah, Muhammad</dc:creator>
	<dc:subject xml:lang="en-US">bridge pier</dc:subject>
	<dc:subject xml:lang="en-US">concrete jacketing</dc:subject>
	<dc:subject xml:lang="en-US">initial load</dc:subject>
	<dc:subject xml:lang="en-US">interface slip</dc:subject>
	<dc:subject xml:lang="en-US">moment-curvature</dc:subject>
	<dc:subject xml:lang="en-US">plastic hinge model</dc:subject>
	<dc:subject xml:lang="en-US">pushover analysis</dc:subject>
	<dc:subject xml:lang="en-US">retrofit</dc:subject>
	<dc:subject xml:lang="en-US">seismic performance</dc:subject>
	<dc:description xml:lang="en-US">In design practice, the assumptions that are used in retrofitting concrete structural elements often ignore the initial load and the interface slip on the contact surfaces between the old and the new concrete. The concrete structural elements that are loaded by the existing gravity load cause initial strain on the existing cross-section before jacketing is applied, while the interface does not act in a fully composite manner. In this study, a seismic performance evaluation using pushover analysis was performed of a damaged reinforced concrete bridge pier retrofitted with concrete jacketing, where the plastic hinge of the retrofitted elements was modeled by considering both parameters. The results showed that concrete jacketing could increase the capacity of the bridge structure. It was also found from the numerical result that the performance level of the bridge considering the initial load compared to the monolithic approach gave the same result since the initial load did not significantly affect the cross-sectional ultimate capacity. The difference between the ultimate capacity values computed by the two models was less than 7%. It was also shown that the interface slip had a significant effect with a slip coefficient smaller than 0.5.</dc:description>
	<dc:publisher xml:lang="en-US">Directorate for Research and Community Services, Institut Teknologi Bandung</dc:publisher>
	<dc:date>2020-06-25</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://journals.itb.ac.id/index.php/jets/article/view/11729</dc:identifier>
	<dc:identifier>10.5614/j.eng.technol.sci.2020.52.3.4</dc:identifier>
	<dc:source xml:lang="en-US">Journal of Engineering and Technological Sciences; Vol. 52 No. 3 (2020); 343-369</dc:source>
	<dc:source>2338-5502</dc:source>
	<dc:source>2337-5779</dc:source>
	<dc:source>10.5614/j.eng.technol.sci.2020.52.3</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://journals.itb.ac.id/index.php/jets/article/view/11729/pdf_70</dc:relation>
</oai_dc:dc>