Melola Discovery

← Melola Discovery

Jurnal SINTA 1

Optimization of Proportional Integral Derivative Controller for Omni Robot Wheel Drive by Using Integrator Wind-up Reduction Based on Arduino Nano

Journal of Robotics and Control (JRC) · Vol. 5 No. 6 (2024) · hlm. 1690–1701

DOI
10.18196/jrc.v5i6.21807
ISSN
2715-5072, 2715-5056
Terbit
2024-09-09
Penerbit
Universitas Muhammadiyah Yogyakarta
Bahasa
eng

Abstrak

The experimental object used is a three-wheeled omni-robot frame, where the wheel axes have an angle difference of 120 degrees from each other. The Omni wheels have a diameter of 48 mm connected to the DC motor axis through a gearbox, which has a ratio of 80 to 1. Each wheel has been controlled using a proportional plus integral plus derivative (PID) controller embedded in a microcontroller, which is an Arduino nano board. The motor axis is equipped with a two-phase optical encoder that definitively generates four cycles per revolution for wheel speed acquisition as the controller input. The wheel speed control signal is distributed to the wheel through the H bridge as the controller output. The controller constants have been directly tuned to the robot frame's physical omni-wheel speed control system. The controller is tuned to minimize steady-state error, achieve fast settling times, and minimize overshoot. The best constants obtained are 1.5 (proportional), 0.012 (integral), and 10 (derivative). Using a tolerance band of +/- 2.5%, the system achieved a settling time of 1.1 seconds and a steady-state error of 0.3%. The control system is unstable when the actuator is saturated, which produces oscillations. Controller optimization has been successful by using integrator wind-up reduction. The steady-state average error was reduced to 9.95% without oscillation after optimization, compared to 46.37% with oscillations before optimization. The controller has been validated with speed-tracking tests on all velocity vector regions. The robot frame has been tested with basic maneuvers such as rotation, concerning, forward, and sideways.

Kata kunci

Jaringan kolaborasi para penulis

34 penulis · 111 tautan kepenulisan bersama · 32 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Politeknik Negeri Samarinda
  • Universitas Sulawesi Tenggara
  • Universitas Islam Negeri Alauddin Makassar
  • Universitas Halu Oleo
  • Universitas Islam Negeri Ar-Raniry
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Supriadi SupriadiPoliteknik Negeri Samarinda4
Achmad Fanany Onnilita GaffarPoliteknik Negeri Samarinda4
Syarifah NurPoliteknik Negeri Samarinda1
Arief Bramanto Wicaksono PPoliteknik Negeri Samarinda1
Rizka Indah ArmiantiPoliteknik Negeri Samarinda1
La Ode MunawirUniversitas Sulawesi Tenggara1
Nindy Ade MarsalenaUniversitas Sulawesi Tenggara1
Niken Yulia YusufUniversitas Sulawesi Tenggara1
Ramli RamliUniversitas Halu Oleo1
Jhony ArjoniUniversitas Sulawesi Tenggara1
Rahmat ManafUniversitas Sulawesi Tenggara1
Rofy UsyanUniversitas Sulawesi Tenggara1
Lasania LasaniaUniversitas Sulawesi Tenggara1
Iyan SofyanUniversitas Sulawesi Tenggara1
Virya SuprayogiUniversitas Sulawesi Tenggara1
M YusufUniversitas Islam Negeri Ar-Raniry1
Tadjuddin MaknunAfiliasi tidak diketahui1
Ikhwan M. SaidAfiliasi tidak diketahui1
Muhammad WahyudiPoliteknik Negeri Samarinda1
Hari PurwadiPoliteknik Negeri Samarinda1
Hermawan Pamot RaharjoAfiliasi tidak diketahui1
Donny Wira Yudha KusumaAfiliasi tidak diketahui1
uupriadi UppyAfiliasi tidak diketahui1
Irsan KaharAfiliasi tidak diketahui1
Andi Alif TunruAfiliasi tidak diketahui1
Syahrir SyahrirAfiliasi tidak diketahui1
Mirna WatiUniversitas Islam Negeri Alauddin Makassar1
Asyraf MustaminUniversitas Islam Negeri Alauddin Makassar1
Awal NurUniversitas Islam Negeri Alauddin Makassar1
Rheo MalaniPoliteknik Negeri Samarinda1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://journal.umy.ac.id/index.php/jrc/oai, pertama di-harvest 9 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">Optimization of Proportional Integral Derivative Controller for Omni Robot Wheel Drive by Using Integrator Wind-up Reduction Based on Arduino Nano</dc:title>
	<dc:creator>Supriadi, Supriadi</dc:creator>
	<dc:creator>Wajiansyah, Agusma</dc:creator>
	<dc:creator>Zainuddin, Mohammad</dc:creator>
	<dc:creator>Putra, Arief Bramanto Wicaksono</dc:creator>
	<dc:subject xml:lang="en-US">Physical Hardware</dc:subject>
	<dc:subject xml:lang="en-US">Manual-Tuning</dc:subject>
	<dc:subject xml:lang="en-US">PID</dc:subject>
	<dc:subject xml:lang="en-US">Integrator Wind-Up</dc:subject>
	<dc:subject xml:lang="en-US">Omni Wheel</dc:subject>
	<dc:subject xml:lang="en-US">Omni Robot</dc:subject>
	<dc:subject xml:lang="en-US">CLI</dc:subject>
	<dc:subject xml:lang="en-US">Arduio Nano</dc:subject>
	<dc:subject xml:lang="en-US">Encoder</dc:subject>
	<dc:subject xml:lang="en-US">CPR</dc:subject>
	<dc:subject xml:lang="en-US">PWM.</dc:subject>
	<dc:description xml:lang="en-US">The experimental object used is a three-wheeled omni-robot frame, where the wheel axes have an angle difference of 120 degrees from each other. The Omni wheels have a diameter of 48 mm connected to the DC motor axis through a gearbox, which has a ratio of 80 to 1. Each wheel has been controlled using a proportional plus integral plus derivative (PID) controller embedded in a microcontroller, which is an Arduino nano board. The motor axis is equipped with a two-phase optical encoder that definitively generates four cycles per revolution for wheel speed acquisition as the controller input. The wheel speed control signal is distributed to the wheel through the H bridge as the controller output. The controller constants have been directly tuned to the robot frame's physical omni-wheel speed control system. The controller is tuned to minimize steady-state error, achieve fast settling times, and minimize overshoot. The best constants obtained are 1.5 (proportional), 0.012 (integral), and 10 (derivative). Using a tolerance band of +/- 2.5%, the system achieved a settling time of 1.1 seconds and a steady-state error of 0.3%. The control system is unstable when the actuator is saturated, which produces oscillations. Controller optimization has been successful by using integrator wind-up reduction. The steady-state average error was reduced to 9.95% without oscillation after optimization, compared to 46.37% with oscillations before optimization. The controller has been validated with speed-tracking tests on all velocity vector regions. The robot frame has been tested with basic maneuvers such as rotation, concerning, forward, and sideways.</dc:description>
	<dc:publisher xml:lang="en-US">Universitas Muhammadiyah Yogyakarta</dc:publisher>
	<dc:date>2024-09-09</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://journal.umy.ac.id/index.php/jrc/article/view/21807</dc:identifier>
	<dc:identifier>10.18196/jrc.v5i6.21807</dc:identifier>
	<dc:source xml:lang="en-US">Journal of Robotics and Control (JRC); Vol. 5 No. 6 (2024); 1690-1701</dc:source>
	<dc:source>2715-5072</dc:source>
	<dc:source>2715-5056</dc:source>
	<dc:source>10.18196/jrc.v5i6</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://journal.umy.ac.id/index.php/jrc/article/view/21807/9459</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2024 Supriadi, Agusma Wajiansyah, Mohammad Zainuddin, Arief Bramanto Wicaksono Putra</dc:rights>
</oai_dc:dc>