Melola Discovery

← Melola Discovery

Jurnal SINTA 1

The Influence of Temperature Variations on Rigid Pavement Concrete Slabs

Journal of the Civil Engineering Forum · Vol. 9 No. 2 (2023) · hlm. 139–150

DOI
10.22146/jcef.5744
ISSN
2549-5925, 2581-1037
Terbit
2023-05-12
Penerbit
Department of Civil and Environmental Engineering, Faculty of Engineering, Universitas Gadjah Mada
Bahasa
eng

Abstrak

This research aims to assess the effect of temperature gradient developed within the concrete slab of rigid pavement, and to investigate its impact when incorporated with the traffic load, and the heat transfer pattern. The rigid pavement model considers an isotropic, uniform, and linear-elastic schemes to simulate the material properties. A numerical analysis approach was employed using Abaqus software incorporated with the 3D Solid model. The traffic loads were obtained from the field surveys, while the temperature of the slabs was measured directly on the site. The dimension of the rigid panel is 2.75 m in width, 5 m long, slab thickness of 25 cm, and concrete specification of 41.33 MPa. The results showed that the temperature gradient produced a significant impact on stress development within the concrete slab of rigid pavement. It was observed that the temperature gradient during the daytime generated higher stress than at night, with a value reaching the MOR (Modulus of Rupture). The exposure of the rigid pavement to 500C tends to produce a principle slab stress of 2.395 MPa, while 1.31 MPa was developed due to the traffic load. When the two factors were combined, the concrete slab acquired a maximum principle stress of 3.322 MPa, which is close to the MOR of 83.34% fa. These results showed that the pavement is capable of withstanding stress from temperature gradient and traffic load as indicated by the ratio of less than one (1). However, this ratio is high for fatigue failure mitigation purposes, and this reduces the quality of life of the rigid pavement.

Kata kunci

Jaringan kolaborasi para penulis

23 penulis · 67 tautan kepenulisan bersama · 26 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Universitas Gadjah Mada
  • Universiti Teknologi MARA
  • Universitas Cokroaminoto Yogyakarta
  • Indonesian Institute of Sciences
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Bambang SupriyadiUniversitas Gadjah Mada2
Angga Fajar SetiawanUniversitas Gadjah Mada2
Taqia RahmanUniversitas Gadjah Mada1
Wardhani SartonoUniversitas Gadjah Mada1
Purbolaras NawangalamUniversitas Gadjah Mada1
Hary Christady HardiyatmoUniversitas Gadjah Mada1
Akhmad AminullahUniversitas Gadjah Mada1
Ali AwaludinUniversitas Gadjah Mada1
Wira Sucitra IbrahimUniversitas Gadjah Mada1
Renga Rao KrishnamoorthyUniversiti Teknologi MARA1
Luki Hariando PurbaUniversitas Gadjah Mada1
Muhammad Akhsin MuflikhunUniversitas Gadjah Mada1
Noorsuhada Md NorUniversiti Teknologi MARA1
Oktalia Wuranti PutriUniversitas Gadjah Mada1
MuslikhUniversitas Cokroaminoto Yogyakarta1
Gadang PriyotomoIndonesian Institute of Sciences1
Trihol Oky Jones SilabanUniversitas Gadjah Mada1
Ardi WiranataUniversitas Gadjah Mada1
Ryan Anugrah PutraUniversitas Gadjah Mada1
Sakhiah Abdul KudusUniversiti Teknologi MARA1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://jurnal.ugm.ac.id/v3/jcef/oai, pertama di-harvest 9 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">The Influence of Temperature Variations on Rigid Pavement Concrete Slabs</dc:title>
	<dc:creator>Mahfuda, Anno</dc:creator>
	<dc:creator>Siswosukarto, Suprapto</dc:creator>
	<dc:creator>Suhendro, Bambang</dc:creator>
	<dc:subject xml:lang="en-US">Temperature Gradient</dc:subject>
	<dc:subject xml:lang="en-US">Rigid Pavement</dc:subject>
	<dc:subject xml:lang="en-US">Traffic Load</dc:subject>
	<dc:subject xml:lang="en-US">Numerical Analysis</dc:subject>
	<dc:subject xml:lang="en-US">Concrete Slab</dc:subject>
	<dc:description xml:lang="en-US">This research aims to assess the effect of temperature gradient developed within the concrete slab of rigid pavement, and to investigate its impact when incorporated with the traffic load, and the heat transfer pattern. The rigid pavement model considers an isotropic, uniform, and linear-elastic schemes to simulate the material properties. A numerical analysis approach was employed using Abaqus software incorporated with the 3D Solid model. The traffic loads were obtained from the field surveys, while the temperature of the slabs was measured directly on the site. The dimension of the rigid panel is 2.75 m in width, 5 m long, slab thickness of 25 cm, and concrete specification of 41.33 MPa. The results showed that the temperature gradient produced a significant impact on stress development within the concrete slab of rigid pavement. It was observed that the temperature gradient during the daytime generated higher stress than at night, with a value reaching the MOR (Modulus of Rupture). The exposure of the rigid pavement to 500C tends to produce a principle slab stress of 2.395 MPa, while 1.31 MPa was developed due to the traffic load. When the two factors were combined, the concrete slab acquired a maximum principle stress of 3.322 MPa, which is close to the MOR of 83.34% fa. These results showed that the pavement is capable of withstanding stress from temperature gradient and traffic load as indicated by the ratio of less than one (1). However, this ratio is high for fatigue failure mitigation purposes, and this reduces the quality of life of the rigid pavement. </dc:description>
	<dc:publisher xml:lang="en-US">Department of Civil and Environmental Engineering, Faculty of Engineering, Universitas Gadjah Mada</dc:publisher>
	<dc:date>2023-05-12</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US">Peer-reviewed Article</dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://jurnal.ugm.ac.id/v3/JCEF/article/view/5744</dc:identifier>
	<dc:identifier>10.22146/jcef.5744</dc:identifier>
	<dc:source xml:lang="en-US">Journal of the Civil Engineering Forum; Vol. 9 No. 2 (May 2023); 139-150</dc:source>
	<dc:source>2549-5925</dc:source>
	<dc:source>2581-1037</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://jurnal.ugm.ac.id/v3/JCEF/article/view/5744/2548</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2023 The Author(s)</dc:rights>
</oai_dc:dc>