Melola Discovery

← Melola Discovery

Jurnal SINTA 1

The Effect of Pyrolysis Temperature on the Performance of Sewage Sludge Biochar for Persulfate-based Oxidation of Bisphenol-A

Journal of the Civil Engineering Forum · Vol. 12 No. 1 (2025) · hlm. 104–121

DOI
10.22146/jcef.22632
ISSN
2549-5925, 2581-1037
Terbit
2025-11-27
Penerbit
Department of Civil and Environmental Engineering, Faculty of Engineering, Universitas Gadjah Mada
Bahasa
eng

Abstrak

Converting sewage sludge into biochar shows promise as an eco-friendly and cost-effective method for remediating pollutants. In this study, aerobic digested sewage sludge was evaluated as a low-cost carbon-based catalyst through a facile one-pot pyrolysis process. The sludge biochar (SBC) was then used as a persulfate (PS) activator for the degradation of Bisphenol-A (BPA). The effect of pyrolysis temperature on the physicochemical properties of SBC and catalytic activity was observed. Then, chemical quenching analysis was carried out to identify reactive species. Increasing the pyrolysis temperature from 350 to 700 °C resulted in an enhancement of the degradation rate constant of BPA from 0.95 × 10-2 min-1 to 8.9 × 10-2 min-1. SBC pyrolyzed at 350 °C (A350), characterized by a high iron content (40%wt) in the form of amorphous Fe (e.g., ferrihydrite) and C=C functional group promoting the radical formation which is dominated by presence of hydroxyl radicals. However, iron in an amorphous form limited the catalytic activity of A350. By contrast, non-radical pathway dominates SBC pyrolyzed at 700 °C (A700) with highest BPA removal as the result of more hydrophobic nature (lower O/C) therefore attracting more BPA and PS to the biochar surface. Graphitic structure of A700 (lower ID/IG) supports the mediated electron transfer pathway for persulfate activation. A pH range of 2–9 and the of inorganic anions (e.g., Cl-,NO3-,SO4-, and HCO3-) had negligible effects on the A700 system. This study introduces a novel approach to the value-added reuse of sewage sludge as an efficient persulfate activator for pollutant remediation with good resistance to water matrices conditions.

Kata kunci

Jaringan kolaborasi para penulis

6 penulis · 9 tautan kepenulisan bersama · 5 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Universitas Gadjah Mada
  • Korea University
  • Chulalongkorn University
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Tantri N. HandayaniUniversitas Gadjah Mada1
Kartika Nur Rahma PutriUniversitas Gadjah Mada1
Veerasak LikhitruangsilpChulalongkorn University1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://jurnal.ugm.ac.id/v3/jcef/oai, pertama di-harvest 9 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">The Effect of Pyrolysis Temperature on the Performance of Sewage Sludge Biochar for Persulfate-based Oxidation of Bisphenol-A</dc:title>
	<dc:creator>Istiqomah, Nurul Alvia</dc:creator>
	<dc:creator>Nguyen, Thi Vinh </dc:creator>
	<dc:creator>Maulana, Dick Dick </dc:creator>
	<dc:subject xml:lang="en-US">Sewage sludge</dc:subject>
	<dc:subject xml:lang="en-US">Biochar</dc:subject>
	<dc:subject xml:lang="en-US">Persulfate activation</dc:subject>
	<dc:subject xml:lang="en-US">AOPs</dc:subject>
	<dc:subject xml:lang="en-US">BPA</dc:subject>
	<dc:description xml:lang="en-US">Converting sewage sludge into biochar shows promise as an eco-friendly and cost-effective method for remediating pollutants. In this study, aerobic digested sewage sludge was evaluated as a low-cost carbon-based catalyst through a facile one-pot pyrolysis process. The sludge biochar (SBC) was then used as a persulfate (PS) activator for the degradation of Bisphenol-A (BPA). The effect of pyrolysis temperature on the physicochemical properties of SBC and catalytic activity was observed. Then, chemical quenching analysis was carried out to identify reactive species. Increasing the pyrolysis temperature from 350 to 700 °C resulted in an enhancement of the degradation rate constant of BPA from 0.95 × 10-2 min-1 to 8.9 × 10-2 min-1. SBC pyrolyzed at 350 °C (A350), characterized by a high iron content (40%wt) in the form of amorphous Fe (e.g., ferrihydrite) and C=C functional group promoting the radical formation which is dominated by presence of hydroxyl radicals. However, iron in an amorphous form limited the catalytic activity of A350. By contrast, non-radical pathway dominates SBC pyrolyzed at 700 °C (A700) with highest BPA removal as the result of more hydrophobic nature (lower O/C) therefore attracting more BPA and PS to the biochar surface. Graphitic structure of A700 (lower ID/IG) supports the mediated electron transfer pathway for persulfate activation. A pH range of 2–9 and the of inorganic anions (e.g., Cl-,NO3-,SO4-, and HCO3-) had negligible effects on the A700 system. This study introduces a novel approach to the value-added reuse of sewage sludge as an efficient persulfate activator for pollutant remediation with good resistance to water matrices conditions.</dc:description>
	<dc:publisher xml:lang="en-US">Department of Civil and Environmental Engineering, Faculty of Engineering, Universitas Gadjah Mada</dc:publisher>
	<dc:date>2025-11-27</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US">Peer-reviewed Article</dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://jurnal.ugm.ac.id/v3/JCEF/article/view/22632</dc:identifier>
	<dc:identifier>10.22146/jcef.22632</dc:identifier>
	<dc:source xml:lang="en-US">Journal of the Civil Engineering Forum; Vol. 12 No. 1 (January 2026); 104-121</dc:source>
	<dc:source>2549-5925</dc:source>
	<dc:source>2581-1037</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://jurnal.ugm.ac.id/v3/JCEF/article/view/22632/6448</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2026 The Author(s)</dc:rights>
</oai_dc:dc>