Melola Discovery

← Melola Discovery

Jurnal SINTA 1

NUMERICAL SIMULATION ON REAR SPOILER ANGLE OF MINI MPV CAR FOR CONDUCTING STABILITY AND SAFETY

Sinergi · Vol. 24 No. 1 (2019) · hlm. 23–28

DOI
10.22441/sinergi.2020.1.004
ISSN
2460-1217, 1410-2331
Terbit
2019-12-04
Penerbit
Universitas Mercu Buana
Bahasa
eng

Abstrak

Spoiler attached on the rear part of a car can generate drag force and negative lift force, called downforce. This drag force can increase air resistance to the car, meanwhile, a negative lift force can improve the car’s stability and safety. Refer to many researchers, the shape and the angle of the spoiler give different aerodynamic effects and therefore give a different value of drag force and lift force. Based on these facts, this study was focused on the analysis of different spoiler angle attached to a mini MPV car to drag and lift force generated by the spoiler. The method used in this study is a numerical simulation using the Computational Fluid Dynamics (CFD) technique. The analysis was carried out at different spoiler angle and car’s speed. The spoiler angles are -20o, -10o, 0o, 10o, and 20o. The car’s speeds are 40 km/h, 60 km/h, 80 km/h, 100 km/h, and 120 km/h. Then the drag and lift force and their coefficient generated by different spoiler angles were being investigated at specified speeds. The result shows that higher spoiler angles generate higher drag and lower lift. Spoiler angles higher than 0o generate negative lift force, otherwise generate positive lift force. Therefore, to increase a car’s stability and safety, it is recommended to use a spoiler angle higher than 0o. Based on the result, it is best to use spoiler angle 10o because it generates negative lift force with -0.05 lift coefficient and 0,68 drag coefficient.

Kata kunci

Jaringan kolaborasi para penulis

40 penulis · 135 tautan kepenulisan bersama · 70 lintas organisasi · menampilkan 40 yang paling banyak terhubung

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Mercu Buana University
  • Beijing Institute of Technology
  • Universitas Ahmad Dahlan
  • Kyushu University
  • Nanjing University of Science and Technology
  • Ungku Omar Polytechnic
  • National University of Malaysia
  • Organisasi lain
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Dafit FeriyantoMercu Buana University6
Fajar AnggaraMercu Buana University6
Rikko Putra YouliaMercu Buana University5
Aberham Genetu FelekeBeijing Institute of Technology4
Wiwit SuprihatiningsihMercu Buana University3
Hui XiongBeijing Institute of Technology3
L. B. Desti DorionNanjing University of Science and Technology3
Muhamad FitriMercu Buana University2
Hadi PranotoMercu Buana University2
Nurato NuratoMercu Buana University2
Supaat ZakariaUngku Omar Polytechnic2
Yosua Heru IrawanNational Taiwan University of Science and Technology2
Nur IndahNational University of Malaysia1
Rachmat MuwardiMercu Buana University1
Imam HidayatMercu Buana University1
Muhammad ImranBeijing Institute of Technology1
Aya HagishimaKyushu University1
Muchlis MuchlisUniversitas AKPRIND Indonesia1
Sulistyawati SulistyawatiUniversitas Ahmad Dahlan1
Nurkhasanah MahfudhUniversitas Ahmad Dahlan1
Dian PrasastiUniversitas Ahmad Dahlan1
Anugrah Tri AnandaUniversitas Ahmad Dahlan1
Frida RahmawatiUniversitas Ahmad Dahlan1
Nanang RuhyatMercu Buana University1
Andi Firdaus SudarmaMercu Buana University1
Hifdzul Luthfan HabibullahMercu Buana University1
Diah UtamiMercu Buana University1
Yang XiaweiNorthwestern Polytechnical University1
Yudha Aji PramonoMercu Buana University1
Fathoni Putra WijayaAfiliasi tidak diketahui1
Dong WangBeijing Institute of Technology1
Muhammad ImranBeijing Institute of Technology1
Himawan S. WibisonoMercu Buana University1
Agung Wahyudi BiantoroMercu Buana University1
Tri Wahyu AdinartoMercu Buana University1
Fatkur RachmanuPoliteknik Enjinering Indorama1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://publikasi.mercubuana.ac.id/index.php/sinergi/oai, pertama di-harvest 10 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">NUMERICAL SIMULATION ON REAR SPOILER ANGLE OF MINI MPV CAR FOR CONDUCTING STABILITY AND SAFETY</dc:title>
	<dc:creator>Luthfie, Alief Avicenna</dc:creator>
	<dc:creator>Romahadi, Dedik</dc:creator>
	<dc:creator>Ghufron, Hanif</dc:creator>
	<dc:creator>Murtyas, Solli Dwi</dc:creator>
	<dc:subject xml:lang="en-US">Mini MPV car</dc:subject>
	<dc:subject xml:lang="en-US">rear spoiler angle</dc:subject>
	<dc:subject xml:lang="en-US">drag</dc:subject>
	<dc:subject xml:lang="en-US">lift</dc:subject>
	<dc:subject xml:lang="en-US">numerical simulation</dc:subject>
	<dc:description xml:lang="en-US">Spoiler attached on the rear part of a car can generate drag force and negative lift force, called downforce. This drag force can increase air resistance to the car, meanwhile, a negative lift force can improve the car’s stability and safety. Refer to many researchers, the shape and the angle of the spoiler give different aerodynamic effects and therefore give a different value of drag force and lift force. Based on these facts, this study was focused on the analysis of different spoiler angle attached to a mini MPV car to drag and lift force generated by the spoiler. The method used in this study is a numerical simulation using the Computational Fluid Dynamics (CFD) technique. The analysis was carried out at different spoiler angle and car’s speed. The spoiler angles are -20o, -10o, 0o, 10o, and 20o. The car’s speeds are 40 km/h, 60 km/h, 80 km/h, 100 km/h, and 120 km/h. Then the drag and lift force and their coefficient generated by different spoiler angles were being investigated at specified speeds. The result shows that higher spoiler angles generate higher drag and lower lift. Spoiler angles higher than 0o generate negative lift force, otherwise generate positive lift force. Therefore, to increase a car’s stability and safety, it is recommended to use a spoiler angle higher than 0o. Based on the result, it is best to use spoiler angle 10o because it generates negative lift force with -0.05 lift coefficient and 0,68 drag coefficient. </dc:description>
	<dc:publisher xml:lang="en-US">Universitas Mercu Buana</dc:publisher>
	<dc:date>2019-12-04</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US">Peer-reviewed Article</dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://publikasi.mercubuana.ac.id/index.php/sinergi/article/view/5833</dc:identifier>
	<dc:identifier>10.22441/sinergi.2020.1.004</dc:identifier>
	<dc:source xml:lang="en-US">SINERGI; Vol. 24 No. 1 (2020); 23-28</dc:source>
	<dc:source>2460-1217</dc:source>
	<dc:source>1410-2331</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://publikasi.mercubuana.ac.id/index.php/sinergi/article/view/5833/3155</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2020 SINERGI</dc:rights>
</oai_dc:dc>