Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

Preparation of Nickel/Active Carboncatalyst and its Utilization for Benzene Hydrogenation

Indonesian Journal of Chemistry · Vol. 1 No. 2 (2010) · hlm. 105–110

DOI
10.22146/ijc.21951
ISSN
1411-9420, 2460-1578
Terbit
2010-06-03
Penerbit
Gadjah Mada University
Bahasa
en
Lisensi
creativecommons.org/licenses/by-nc-nd/4.0/

Abstrak

The research on the preparation of nickel catalyst impregnated on active carbon by two methods has been carried out. The impregnation of Ni metal was done using nickel(II) chloride as a precursor. The impregnated of Ni metal on samples in A method was made in varying of percentage i.e., 0.5, 1.0 and 2.0% (w/w) as the weight proportion of Ni to active carbon and NiCl2.6H20. The concentration of Ni that would be impregnated on samples in B method was made close to Ni content of samples in A method determined by atomic adsorption spectrometry. Preparation of nickel/active carbon catalyst with A method was done with dipping the active carbon in the nickel(II) chloride solution followed by filtering and then drying at 110 °C for 4 hours, and then calcination by flowing nitrogen and reduction by hydrogen, each at 400 °C at 4 hours. The treatments made on samples in A method was also done on samples in B method, the only difference was evaporating all of precursor solution after dipping active carbon in that precursor solution was done in B method. The characterization includes: iodium adsorption test, determination of nickel content by means of atomic adsorption spectrometry, and acidity by adsorption of ammonia methods. Test of catalyst activity was done by means of hydrogenation of benzene to cyclohexane at 150, 200 and 250 °C, the pressure of 1 atm and the flow rate of hydrogen 6 mL/minute. The products were analyzed by gas chromatographic method. The results show that A method produced a catalyst with relatively low nickel content. However the acidity and ability to convert benzene to cyclohexane were relatively high and it increased as increasing the content of nickel. The temperature of the reaction was achieved at 250 °C which gave the yield on conversion of 25.3678%. The catalyst obtained by B method in the same condition of hydrogenation gave only smaller results.

Kata kunci

Jaringan kolaborasi para penulis

30 penulis · 81 tautan kepenulisan bersama · 15 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Universitas Gadjah Mada
  • State University of Jakarta
  • Sebelas Maret University
  • Universitas Syiah Kuala
  • University of Palangka Raya
  • Lambung Mangkurat University
  • Indonesia University of Education
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Wega TrisunaryantiUniversitas Gadjah Mada9
Triyono TriyonoUniversitas Gadjah Mada7
Muhammad Fajar MarsukiUniversitas Gadjah Mada2
Maya Tri HapsariUniversitas Gadjah Mada2
M. L. PermataUniversitas Gadjah Mada2
Rusman RusmanUniversitas Syiah Kuala2
Djaka SasmitaUniversitas Gadjah Mada2
Maria UlfaSebelas Maret University1
Indriana KartiniUniversitas Gadjah Mada1
Andaru Dena PrasiwiUniversitas Gadjah Mada1
Darma SantiUniversitas Gadjah Mada1
Andreas David SiagianUniversitas Gadjah Mada1
Satriyo Dibyo SumbogoUniversitas Gadjah Mada1
Dwi Bagus WicaksonoUniversitas Gadjah Mada1
Lailatul RahmiUniversitas Gadjah Mada1
Fahri SwasdikaUniversitas Gadjah Mada1
I Made SadianaUniversity of Palangka Raya1
Ruliatima RuliatimaUniversitas Gadjah Mada1
Mokhammad Fajar PradiptaUniversitas Gadjah Mada1
Alvan Luthfi RinaldiUniversitas Gadjah Mada1
M Utoro YahyaUniversitas Gadjah Mada1
Ritmaleni RitmaleniUniversitas Gadjah Mada1
Eko SuhartonoLambung Mangkurat University1
Catur AtmajiUniversitas Gadjah Mada1
Ijang RohmanIndonesia University of Education1
Radianti Novita SariUniversitas Gadjah Mada1
Dyah Ayu FatmawatiUniversitas Gadjah Mada1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OpenAlex API (jurnal SINTA, ADR 0048) https://openalex.org/S2764840418, pertama di-harvest 19 Nov 2026, terakhir terlihat 19 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/"><dc:title xml:lang="en">Preparation of Nickel/Active Carboncatalyst and its Utilization for Benzene Hydrogenation</dc:title><dc:creator>Enggelena Septiawati</dc:creator><dc:creator>Iip Izul Falah</dc:creator><dc:creator>Rha. Sahirul Alim</dc:creator><dc:subject>benzene hydrogenation</dc:subject><dc:subject>cyclohexane production</dc:subject><dc:subject>impregnation method</dc:subject><dc:subject>catalyst preparation</dc:subject><dc:subject>catalyst acidity</dc:subject><dc:subject>hydrogen reduction</dc:subject><dc:subject>calcination</dc:subject><dc:subject>nickel content</dc:subject><dc:description xml:lang="en">The research on the preparation of nickel catalyst impregnated on active carbon by two methods has been carried out. The impregnation of Ni metal was done using nickel(II) chloride as a precursor. The impregnated of Ni metal on samples in A method was made in varying of percentage i.e., 0.5, 1.0 and 2.0% (w/w) as the weight proportion of Ni to active carbon and NiCl2.6H20. The concentration of Ni that would be impregnated on samples in B method was made close to Ni content of samples in A method determined by atomic adsorption spectrometry. Preparation of nickel/active carbon catalyst with A method was done with dipping the active carbon in the nickel(II) chloride solution followed by filtering and then drying at 110 °C for 4 hours, and then calcination by flowing nitrogen and reduction by hydrogen, each at 400 °C at 4 hours. The treatments made on samples in A method was also done on samples in B method, the only difference was evaporating all of precursor solution after dipping active carbon in that precursor solution was done in B method. The characterization includes: iodium adsorption test, determination of nickel content by means of atomic adsorption spectrometry, and acidity by adsorption of ammonia methods. Test of catalyst activity was done by means of hydrogenation of benzene to cyclohexane at 150, 200 and 250 °C, the pressure of 1 atm and the flow rate of hydrogen 6 mL/minute. The products were analyzed by gas chromatographic method. The results show that A method produced a catalyst with relatively low nickel content. However the acidity and ability to convert benzene to cyclohexane were relatively high and it increased as increasing the content of nickel. The temperature of the reaction was achieved at 250 °C which gave the yield on conversion of 25.3678%. The catalyst obtained by B method in the same condition of hydrogenation gave only smaller results.</dc:description><dc:publisher>Gadjah Mada University</dc:publisher><dc:date>2010-06-03</dc:date><dc:type>info:eu-repo/semantics/article</dc:type><dc:identifier>http://doi.org/10.22146/ijc.21951</dc:identifier><dc:identifier>10.22146/ijc.21951</dc:identifier><dc:source>Indonesian Journal of Chemistry; Vol 1 No 2 (2010); 105-110</dc:source><dc:source>1411-9420</dc:source><dc:source>2460-1578</dc:source><dc:language>en</dc:language><dc:rights>https://creativecommons.org/licenses/by-nc-nd/4.0/</dc:rights></oai_dc:dc>