Melola Discovery

← Melola Discovery

Jurnal SINTA 3

The Effect of Baffle Spiral on The Performance of Heat Exchanger

Logic: Jurnal Rancang Bangun dan Teknologi · Vol. 18 No. 3 (2018) · hlm. 86–91

DOI
10.31940/logic.v18i3.1132
ISSN
2580-5649, 1412-114X
Terbit
2018-11-30
Penerbit
Pusat Penelitian dan Pengabdian kepada Masyarakat (P3M) Politeknik Negeri Bali
Bahasa
eng

Abstrak

The application of heat exchanger still causes many problems. Research on the performance improvement of the heat exchanger is also conducted by adding baffle. This research is aimed at finding out the influence of spiral baffle on the performance of heat exchanger. Research is conducted by doing experiment. The heat exchanger used is the opposite flow type. The independent variable includes round and triangular springs with gap spacing of 1, 2 and 3 cm which are installed in the heat pipe. The flow rate of the water is varied by 100, 150, 200 and 250 ml / sec. The dependent variable includes the temperature of hot water (in and out) and the temperature of cold water (in and out). Temperature measurement is done by using a K type thermocouple every minute for 5 minutes. Discharge measurement is done by using flow meter and stopwatch. The results showed that there were effects of the spiral and water discharge variation on the rate of heat transfer. The phenomenon of water discharge is inversely proportional to the rate of temperature change. Maximum heat temperature displacement occurred at a variation of 1.5 cm with a flow rate of 31.25 was 1.44o. The minimum heat transfer temperature occurred at a variation of 0.5 cm with a flow rate of 38.46 was 0.82o. The maximum cold temperature heat transfer occurred at a variation of 1.5 cm with a flow rate of 31.25 was 0.52o and the minimum occurred at variation of 0.5 cm with a flow discharge of 38.46 was 0.14o.

Jaringan kolaborasi para penulis

16 penulis · 36 tautan kepenulisan bersama · 9 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Universitas Pgri Banyuwangi
  • Universitas Muhammadiyah Jember
  • University of Brawijaya
  • Nanyang Technological University
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Rezki NalandariUniversitas Pgri Banyuwangi3
Adi MulyadiUniversitas Pgri Banyuwangi2
Mokh. Hairul BahriUniversitas Muhammadiyah Jember2
Megandhi Gusti WardhanaUniversitas Pgri Banyuwangi2
Willy Satrio NugrohoUniversity of Brawijaya1
Abdul Mudjib Sulaiman WahidNanyang Technological University1
Dewi SartikaUniversitas Pgri Banyuwangi1
Wisnu KuncoroUniversitas Pgri Banyuwangi1
Gatut RubionoUniversitas Pgri Banyuwangi1
Dudi IrawanUniversitas Muhammadiyah Jember1
Muhamad Khoirul AnamUniversitas Pgri Banyuwangi1
Muhammad Zainal Roisul AminUniversitas Pgri Banyuwangi1
Harwanti NoviandariAfiliasi tidak diketahui1
Charis Fathul HadiUniversitas Pgri Banyuwangi1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://ojs.pnb.ac.id/index.php/LOGIC/oai, pertama di-harvest 19 Nov 2026, terakhir terlihat 19 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">The Effect of Baffle Spiral on The Performance of Heat Exchanger</dc:title>
	<dc:creator>Putra, Adi Pratama</dc:creator>
	<dc:creator>Qiram, Ikhwanul</dc:creator>
	<dc:description xml:lang="en-US">The application of heat exchanger still causes many problems. Research on the performance improvement of the heat exchanger is also conducted by adding baffle. This research is aimed at finding out the influence of spiral baffle on the performance of heat exchanger. Research is conducted by doing experiment. The heat exchanger used is the opposite flow type. The independent variable includes round and triangular springs with gap spacing of 1, 2 and 3 cm which are installed in the heat pipe. The flow rate of the water is varied by 100, 150, 200 and 250 ml / sec. The dependent variable includes the temperature of hot water (in and out) and the temperature of cold water (in and out). Temperature measurement is done by using a K type thermocouple every minute for 5 minutes. Discharge measurement is done by using flow meter and stopwatch. The results showed that there were effects of the spiral and water discharge variation on the rate of heat transfer. The phenomenon of water discharge is inversely proportional to the rate of temperature change. Maximum heat temperature displacement occurred at a variation of 1.5 cm with a flow rate of 31.25 was 1.44o. The minimum heat transfer temperature occurred at a variation of 0.5 cm with a flow rate of 38.46 was 0.82o. The maximum cold temperature heat transfer occurred at a variation of 1.5 cm with a flow rate of 31.25 was 0.52o and the minimum occurred at variation of 0.5 cm with a flow discharge of 38.46 was 0.14o.</dc:description>
	<dc:publisher xml:lang="en-US">Pusat Penelitian dan Pengabdian kepada Masyarakat (P3M) Politeknik Negeri Bali</dc:publisher>
	<dc:date>2018-11-30</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US">Peer-reviewed Article</dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://ojs.pnb.ac.id/index.php/LOGIC/article/view/1132</dc:identifier>
	<dc:identifier>10.31940/logic.v18i3.1132</dc:identifier>
	<dc:source xml:lang="en-US">Logic : Jurnal Rancang Bangun dan Teknologi; Vol 18 No 3 (2018): November; 86-91</dc:source>
	<dc:source>2580-5649</dc:source>
	<dc:source>1412-114X</dc:source>
	<dc:source>10.31940/logic.v18i3</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://ojs.pnb.ac.id/index.php/LOGIC/article/view/1132/877</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2018 Logic : Jurnal Rancang Bangun dan Teknologi</dc:rights>
</oai_dc:dc>