Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

SENSORLESS SPEED ESTIMATION OF THREE PHASE INDUCTION MOTORS BASED ON DYNAMIC MODEL

Jurnal Ilmiah Ilmu Terapan Universitas Jambi · Vol. 8 No. 2 (2024) · hlm. 610–621

DOI
10.22437/jiituj.v8i2.32862
ISSN
2580-2259, 2580-2240
Terbit
2024-09-14
Penerbit
LPPM Universitas Jambi
Bahasa
en
Lisensi
creativecommons.org/licenses/by/4.0

Abstrak

In speed control systems of induction motor electrical drives, real-time speed monitoring is necessary. Speed monitoring can be done using the direct method, which uses a mechanical sensor mounted on the motor shaft, or the indirect method, which is based on estimation, mainly from the dynamic model of the motor. Speed estimation based on the dynamic model of the motor in orthogonal coordinates is the most widespread method in sensorless speed control systems of three-phase squirrel cage induction motor electrical drives, especially those of high accuracy. This paper presents the open-loop speed estimator used for speed estimation in three-phase induction motors. The proposed speed estimators are based on the orthogonal coordinate’s dynamic model of an induction motor in a stator reference frame. This technical solution is simple and has a low cost. The currents and voltages of the two motor phases are the input variables of the estimator, while the output variable is the induction motor speed. The speed estimator model is built using LabVIEW software. The dynamics and accuracy of the estimator proposed in this paper have been tested experimentally. The speed measured by the industrial incremental encoder is compared with that of a speed estimator modeled in LabVIEW software. The obtained experimental results show a good match between the measured and estimated speeds under the step torque load changes of the induction motor.

Kata kunci

Jaringan kolaborasi para penulis

4 penulis · 5 tautan kepenulisan bersama

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Polytechnic University of Tirana
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Andi HidaPolytechnic University of Tirana2

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://online-journal.unja.ac.id/index.php/JIITUJ/oai, pertama di-harvest 5 Nov 2026, terakhir terlihat 15 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en">SENSORLESS SPEED ESTIMATION OF THREE PHASE INDUCTION MOTORS BASED ON DYNAMIC MODEL</dc:title>
	<dc:creator xml:lang="en">Pjetri, Alfred</dc:creator>
	<dc:creator xml:lang="en">Bardhi, Astrit</dc:creator>
	<dc:creator xml:lang="en">Dume, Gentian</dc:creator>
	<dc:subject xml:lang="en">Dynamic Model</dc:subject>
	<dc:subject xml:lang="en">Induction Motors</dc:subject>
	<dc:subject xml:lang="en">Sensorless Electrical Drives</dc:subject>
	<dc:subject xml:lang="en">Sensorless Speed Estimation in Induction Motors</dc:subject>
	<dc:description xml:lang="en">In speed control systems of induction motor electrical drives, real-time speed monitoring is necessary. Speed monitoring can be done using the direct method, which uses a mechanical sensor mounted on the motor shaft, or the indirect method, which is based on estimation, mainly from the dynamic model of the motor. Speed estimation based on the dynamic model of the motor in orthogonal coordinates is the most widespread method in sensorless speed control systems of three-phase squirrel cage induction motor electrical drives, especially those of high accuracy. This paper presents the open-loop speed estimator used for speed estimation in three-phase induction motors. The proposed speed estimators are based on the orthogonal coordinate’s dynamic model of an induction motor in a stator reference frame. This technical solution is simple and has a low cost. The currents and voltages of the two motor phases are the input variables of the estimator, while the output variable is the induction motor speed. The speed estimator model is built using LabVIEW software. The dynamics and accuracy of the estimator proposed in this paper have been tested experimentally. The speed measured by the industrial incremental encoder is compared with that of a speed estimator modeled in LabVIEW software. The obtained experimental results show a good match between the measured and estimated speeds under the step torque load changes of the induction motor.</dc:description>
	<dc:publisher xml:lang="en">LPPM Universitas Jambi</dc:publisher>
	<dc:date>2024-09-14</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://online-journal.unja.ac.id/JIITUJ/article/view/32862</dc:identifier>
	<dc:identifier>10.22437/jiituj.v8i2.32862</dc:identifier>
	<dc:source xml:lang="en">Jurnal Ilmiah Ilmu Terapan Universitas Jambi; Vol. 8 No. 2 (2024): Volume 8, Nomor 2, December 2024; 610-621</dc:source>
	<dc:source>2580-2259</dc:source>
	<dc:source>2580-2240</dc:source>
	<dc:language>en</dc:language>
	<dc:relation>https://online-journal.unja.ac.id/JIITUJ/article/view/32862/19062</dc:relation>
	<dc:rights xml:lang="en">Copyright (c) 2024 Alfred Pjetri, Astrit Bardhi, Gentian Dume</dc:rights>
	<dc:rights xml:lang="en">https://creativecommons.org/licenses/by/4.0</dc:rights>
</oai_dc:dc>