Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

IMPROVING U-TURN TRAFFIC PERFORMANCE THROUGH GEOMETRIC DESIGN OPTIMIZATION: EFFECTS ON VEHICLE SPEED AND QUEUE RATIO

Jurnal Ilmiah Ilmu Terapan Universitas Jambi · Vol. 10 No. 4 (2026) · hlm. 2032–2041

DOI
10.22437/jiituj.v10i4.57222
ISSN
2580-2259, 2580-2240
Terbit
2026-08-31
Penerbit
LPPM Universitas Jambi
Bahasa
en
Lisensi
creativecommons.org/licenses/by/4.0

Abstrak

This study aims to evaluate the performance of existing and alternative U-turn geometric configurations in terms of vehicle speed and queue ratio under varying U-turn demand and traffic directions. Field survey data were analyzed using the Indonesian Highway Capacity Guidelines (PKJI 2023) to determine traffic volume, roadway capacity, degree of saturation, and vehicle speed. A microscopic traffic simulation was subsequently conducted using PTV Vissim to compare the existing U-turn configuration with two alternative geometric designs. The simulation considered U-turn proportions of 5%, 10%, 15%, 20%, and 25% in two traffic directions. Vehicle speed and queue ratio were used as the primary performance indicators. Under the existing configuration, peak-hour vehicle speed decreased to 21.5 km/h in the Margonda Raya direction, while the queue ratio reached approximately 2.8 when 25% of vehicles performed U-turns. Alternative geometric configurations improved traffic performance by increasing vehicle speed and reducing queue formation. Under the same peak-hour condition and 25% U-turn proportion, Alternative 2, a roundabout-type U-turn configuration, increased vehicle speed from 21.5 km/h to 33.19 km/h and reduced the queue ratio from 2.8 to 0.66 in the Margonda Raya direction. However, the effectiveness of the alternatives varied by traffic direction, with Alternative 1 delivering better queue performance in the Bogor Raya direction. The findings indicate that U-turn geometric performance is dependent on both U-turn demand and directional traffic characteristics. Therefore, U-turn design selection should not rely on a single geometric configuration but should consider traffic demand, directional flow characteristics, available road space, and operational performance.

Kata kunci

Jaringan kolaborasi para penulis

9 penulis · 12 tautan kepenulisan bersama · 2 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Jakarta State Polytechnic
  • Bandung Institute of Technology
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Diah Eka RahmawatiJakarta State Polytechnic1
Reyhan Febrian PutraJakarta State Polytechnic1
Denny YatmadiBandung Institute of Technology1
Rommy MartdiantoBandung Institute of Technology1
SujitoAfiliasi tidak diketahui1
Yega MardiansyahJakarta State Polytechnic1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://online-journal.unja.ac.id/index.php/JIITUJ/oai, pertama di-harvest 5 Nov 2026, terakhir terlihat 15 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en">IMPROVING U-TURN TRAFFIC PERFORMANCE THROUGH GEOMETRIC DESIGN OPTIMIZATION: EFFECTS ON VEHICLE SPEED AND QUEUE RATIO</dc:title>
	<dc:creator xml:lang="en">Latifa, Eva Azhra</dc:creator>
	<dc:creator xml:lang="en">Madani, Krismayang</dc:creator>
	<dc:creator xml:lang="en">Sari, Tri Wulan</dc:creator>
	<dc:subject xml:lang="en">Traffic Performance</dc:subject>
	<dc:subject xml:lang="en">U-Turn Facility</dc:subject>
	<dc:subject xml:lang="en">Urban Roads</dc:subject>
	<dc:subject xml:lang="en">Vehicle Speed</dc:subject>
	<dc:description xml:lang="en">This study aims to evaluate the performance of existing and alternative U-turn geometric configurations in terms of vehicle speed and queue ratio under varying U-turn demand and traffic directions. Field survey data were analyzed using the Indonesian Highway Capacity Guidelines (PKJI 2023) to determine traffic volume, roadway capacity, degree of saturation, and vehicle speed. A microscopic traffic simulation was subsequently conducted using PTV Vissim to compare the existing U-turn configuration with two alternative geometric designs. The simulation considered U-turn proportions of 5%, 10%, 15%, 20%, and 25% in two traffic directions. Vehicle speed and queue ratio were used as the primary performance indicators. Under the existing configuration, peak-hour vehicle speed decreased to 21.5 km/h in the Margonda Raya direction, while the queue ratio reached approximately 2.8 when 25% of vehicles performed U-turns. Alternative geometric configurations improved traffic performance by increasing vehicle speed and reducing queue formation. Under the same peak-hour condition and 25% U-turn proportion, Alternative 2, a roundabout-type U-turn configuration, increased vehicle speed from 21.5 km/h to 33.19 km/h and reduced the queue ratio from 2.8 to 0.66 in the Margonda Raya direction. However, the effectiveness of the alternatives varied by traffic direction, with Alternative 1 delivering better queue performance in the Bogor Raya direction. The findings indicate that U-turn geometric performance is dependent on both U-turn demand and directional traffic characteristics. Therefore, U-turn design selection should not rely on a single geometric configuration but should consider traffic demand, directional flow characteristics, available road space, and operational performance.</dc:description>
	<dc:publisher xml:lang="en">LPPM Universitas Jambi</dc:publisher>
	<dc:date>2026-08-31</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://online-journal.unja.ac.id/JIITUJ/article/view/57222</dc:identifier>
	<dc:identifier>10.22437/jiituj.v10i4.57222</dc:identifier>
	<dc:source xml:lang="en">Jurnal Ilmiah Ilmu Terapan Universitas Jambi; Vol. 10 No. 4 (2026): Volume 10, Nomor 4, August 2026; 2032-2041</dc:source>
	<dc:source>2580-2259</dc:source>
	<dc:source>2580-2240</dc:source>
	<dc:language>en</dc:language>
	<dc:relation>https://online-journal.unja.ac.id/JIITUJ/article/view/57222/25504</dc:relation>
	<dc:rights xml:lang="en">Copyright (c) 2026 Eva Azhra Latifa, Krismayang Madani, Tri Wulan Sari</dc:rights>
	<dc:rights xml:lang="en">https://creativecommons.org/licenses/by/4.0</dc:rights>
</oai_dc:dc>