A sigma-delta interface built-in self-test and calibration for microelectromechanical system accelerometer's utilizing interpolation method

Abstract

This work presents the capacitive micromechanical accelerometer with a completely differential high-order switched capacitor sigma-delta modulator interface. Such modulation interface circuit generates one-bit output data using a third sigma-delta modulator low-noise front-end, doing away with the requirement for a second enhanced converter of resolution to encode the feedback route analog signal. A capacitive micromechanical sensor unit with just a greater quality factor has been specifically employed to give greater resolution. The closed-loop and electrical correction control are used to dampen the high-Q values to get the system's stability with high-order. This microelectromechanical system (MEMS) capacitive accelerometer was calibrated using a lookup table and Akima interpolation to find manufacturing flaws by recalculating voltage levels for the test electrodes. To determine the proper electrode voltages for fault compensation, COMSOL software simulates a number of defects upon that spring as well as the fingers of the sensor system. When it comes time for the feedback phase of a proof mass displacement correction, these values are subsequently placed in the lookup table.