Melola Discovery

← Melola Discovery

Jurnal Tanpa peringkat SINTA

IDENTIFICATION OF WHITE NOISE AND 1/f IN CURRENT MIRROR CONFIGURATION BASED ON VDS MOSFET

JOURNAL ONLINE OF PHYSICS · Vol. 7 No. 2 (2022) · hlm. 40–47

DOI
10.22437/jop.v7i2.18167
ISSN
2502-2016
Terbit
2022-06-23
Penerbit
Prodi Fisika FST UNJA
Bahasa
en

Abstrak

Identifying noise in the Current Mirror (CM) circuit is essential to locate noise signals in biosensor applications so that measurements become more accurate and precise. There are two dominant types of noise: white noise, which consists of thermal noise and shot noise, and also low-frequency noise (1/f noise). The main component of the CM circuit is the BS250 type MOSFET, which works by varying the width of the charge carrier channelcontrolled by the voltage at the gate. When the drain is given a voltage, electrons will flow from the source to the drain which generates the noise.This study was carried out to identify the noise in the CM configuration by varying the reference voltage of MOSFET using the PCI-6221 card data integrated with the LabVIEW program. The reference voltage values ​​used are 1 mV, 10 mV, and 100 mV to determine the effect of the input voltage on the CM circuit noise signal, while the measurement frequency is varied from 0.1 Hz to 100 kHz with a resolution of 0.1 Hz. The results show that the noise characteristics vary with the applied voltage, which will increase at a higher voltage. Analysis of 1/f noise at frequencies up to 0.2 Hz has a gradient increase of up to 10 times for each given voltage value. Based on the value of the data distribution on the white noise measurement, it shows that a voltage of 100 mV produces the highest noise with an average of 3.62 × 10-7 Vrms/Hz1/2. The results of this study are used in the design of CM circuits with minimal noise.

Kata kunci

Jaringan kolaborasi para penulis

29 penulis · 95 tautan kepenulisan bersama · 51 lintas organisasi

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • Riau University
  • Jenderal Soedirman University
  • Universitas Riau Indonesia
  • National Research and Innovation Agency
  • Bandung Institute of Technology
  • University of Technology Malaysia
  • State University of Jakarta
  • Organisasi lain
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Vira Annisa RosandiRiau University3
Tengku EmrinaldiRiau University2
DefriantoUniversitas Riau Indonesia2
Sultan Fiddunya FiddunyaUniversitas Riau Indonesia2
Yanuar YanuarRiau University2
Nadratul HanifahRiau University2
Khairul IhsanRiau University2
Erman TaerRiau University2
Febyola AswandiRiau University1
Beny AgustirandyAfiliasi tidak diketahui1
Dina MaryaniRiau University1
Leonardus Riski NainggolanRiau University1
Siti Rahmawati IbmarRiau University1
Sumi KomalaRiau University1
Ridho RijaldiRiau University1
Mitra DjamalBandung Institute of Technology1
Retno SupriyantiJenderal Soedirman University1
Wahyu WidanartoJenderal Soedirman University1
Erfan HandokoState University of Jakarta1
Mukhtar EffendiJenderal Soedirman University1
Dina RahmawatiJenderal Soedirman University1
Sib Krishna GhoshalUniversity of Technology Malaysia1
Candra KurniawanNational Research and Innovation Agency1
Tomy TamtowiJenderal Soedirman University1
Jumaeda JatmikaNational Research and Innovation Agency1
Mudrik AlaydrusMercu Buana University1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://online-journal.unja.ac.id/index.php/jop/oai, pertama di-harvest 6 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en">IDENTIFICATION OF WHITE NOISE AND 1/f  IN CURRENT MIRROR CONFIGURATION BASED ON VDS MOSFET</dc:title>
	<dc:creator xml:lang="en">Gea, Maria Rosariana</dc:creator>
	<dc:creator xml:lang="en">Umar, Lazuardi</dc:creator>
	<dc:creator xml:lang="en">Setiadi, Rahmondia Nanda</dc:creator>
	<dc:subject xml:lang="en">Keywords : Biosensor, Current Mirror; MOSFET BS250; White and 1/f Noise</dc:subject>
	<dc:description xml:lang="en">Identifying noise in the Current Mirror (CM) circuit is essential to locate noise signals in biosensor applications so that measurements become more accurate and precise. There are two dominant types of noise: white noise, which consists of thermal noise and shot noise, and also low-frequency noise (1/f  noise). The main component of the CM circuit is the BS250 type MOSFET, which works by varying the width of the charge carrier channelcontrolled by the voltage at the gate. When the drain is given a voltage, electrons will flow from the source to the drain which generates the noise.This study was carried out to identify the noise in the CM configuration by varying the reference voltage of MOSFET using the PCI-6221 card data integrated with the LabVIEW program. The reference voltage values ​​used are 1 mV, 10 mV, and 100 mV to determine the effect of the input voltage on the CM circuit noise signal, while the measurement frequency is varied from 0.1 Hz to 100 kHz with a resolution of 0.1 Hz. The results show that the noise characteristics vary with the applied voltage, which will increase at a higher voltage. Analysis of 1/f noise at frequencies up to 0.2 Hz has a gradient increase of up to 10 times for each given voltage value. Based on the value of the data distribution on the white noise measurement, it shows that a voltage of 100 mV produces the highest noise with an average of 3.62 × 10-7 Vrms/Hz1/2. The results of this study are used in the design of CM circuits with minimal noise.</dc:description>
	<dc:publisher xml:lang="en">Prodi Fisika FST UNJA</dc:publisher>
	<dc:date>2022-06-23</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://online-journal.unja.ac.id/jop/article/view/18167</dc:identifier>
	<dc:identifier>10.22437/jop.v7i2.18167</dc:identifier>
	<dc:source xml:lang="en">JOURNAL ONLINE OF PHYSICS; Vol. 7 No. 2 (2022): JOP (Journal Online of Physics) Vol 7 No 2; 40-47</dc:source>
	<dc:source>2502-2016</dc:source>
	<dc:language>en</dc:language>
	<dc:relation>https://online-journal.unja.ac.id/jop/article/view/18167/13630</dc:relation>
	<dc:rights xml:lang="en">Copyright (c) 2022 JOURNAL ONLINE OF PHYSICS</dc:rights>
</oai_dc:dc>