Data collection using thermocouple sensors in low-cost data acquisition is prone to noise interference, which could reduce the data quality. Noise sources such as cold junction compensators, electromagnetic interference, and Johnson noise can significantly affect the reliability and accuracy of conventional measurements. This study aims to improve the quality of thermocouple sensor readings on low-cost data acquisition using calibration method based on deep learning and the denoising process using a wavelet transform. This taken approach successfully increase the accuracy value of 97.67% with a mean absolute error (MAE) of 0.2. The precision also increases of 262.7% as indicated by the result of signal-to-noise ratio (SNR) with a value of 105.29 dB. Comparative analysis was carried out against National Instruments® device and it was found that deep-wavelet method had a lower and higher of MAE and SNRdB values of 16.67% and 0.8% respectively. This study shows that the denoising-calibration method with deep-wavelet can improve the accuracy and reliability of data from low-cost thermocouple devices.
Collaboration network of the authors
13 authors ·
30 co-authorship links
· 4 across different organisations
Hover or tap a name to highlight its co-authors. Double-click to open the author's page.
Universitas Pembangunan Nasional Veteran Jakarta
Politeknik Negeri Bali
Kementerian Energi dan Sumber Daya Mineral
Muhammadiyah University of Surakarta
Affiliation unknown
Different organisations
Same organisation
Affiliation unknown
Thicker line = more joint articles · bigger circle = more articles
Affiliations come from OpenAlex; journal OAI-PMH metadata carries none. Authors without an OpenAlex ID are matched by name, which can merge or split people.