Melola Discovery

← Melola Discovery

Akses terbuka Jurnal SINTA 1

The effect of temperature during the hydrocracking of low-density polyethylene using a Ni-Cu/HZSM-5 catalyst

International Journal of Renewable Energy Development : JRED · Vol. 15 No. 4 (2026) · hlm. 797–807

DOI
10.61435/ijred.2026.61922
ISSN
2252-4940
Terbit
2026-07-02
Penerbit
Center of Biomass & Renewable Energy (CBIORE)
Bahasa
eng
Lisensi
creativecommons.org/licenses/by-sa/4.0

Abstrak

LDPE plastics contributed 20-30% of the plastics use. Due to its non-biodegradable properties, plastic waste management is crucial. In the other hand, the LDPE plastics provide potential and benefits in the exploration of energy resources; they could be converted to liquid fuels through a catalytic hydrocracking. This study focuses on the effect of temperatures during the hydrocracking of LDPE using a Ni-Cu/HZSM-5 catalyst. The Ni-Cu/HZSM-5 catalyst was synthesized using the wet impregnation method assisted by an ultrasonic irradiation. The characteristics of the catalyst were evaluated prior to its use during the hydrocracking of LDPE. This study showed that the impregnation of Ni and Cu at HZSM-5 surface did not significantly affect the crystallinity of HZSM-5. Even though the peaks of Ni and Cu in the diffraction pattern were not clearly observed, their presence at HZSM-5 surface was well confirmed by the XRF spectrum. In addition, the hierarchical structure of HZSM-5 was also confirmed by the appearance of microporosity together with the type-IV hysteresis loop on the nitrogen adsorption-desorption isotherm. A considerable decrease (~25%) of the catalyst acidity was observed after the impregnation of Ni and Cu at HZSM-5 surface. The Ni-Cu/HZSM-5 catalyst showed a good activity during the hydrocracking of LDPE at temperatures of 275−400 °C, resulting in liquid, solid, and gaseous products. The yields of the liquid product increased by increasing the hydrocracking temperatures. It was observed that by increasing the hydrocracking temperatures, the yield of the kerosene and diesel fractions decreased, while the yield of the gasoline fraction increased, as supported by the density and calorific value that was close to the commercial gasoline. A further temperature increase would lead to more products with lighter fractions, reducing the yield of gasoline. This was also supported by the presence of alkenes, ketones, and esters formed after the catalytic hydrocracking as shown by the FTIR spectra of the liquid products.

Kata kunci

Jaringan kolaborasi para penulis

40 penulis · 123 tautan kepenulisan bersama · 22 lintas organisasi · menampilkan 40 yang paling banyak terhubung

Arahkan kursor atau ketuk sebuah nama untuk menyorot rekan penulisnya. Klik dua kali untuk membuka halaman penulis.

  • State University of Semarang
  • National Research and Innovation Agency
  • Syarif Hidayatullah State Islamic University Jakarta
  • Hasanuddin University
  • Indonesian Institute of Sciences
  • Universitas Bhayangkara Jakarta Raya
  • State University of Makassar
  • Organisasi lain
  • Afiliasi tidak diketahui
  • Organisasi berbeda
  • Organisasi sama
  • Afiliasi tidak diketahui
  • Garis lebih tebal = lebih banyak artikel bersama · lingkaran lebih besar = lebih banyak artikel
Tampilkan sebagai tabel
Rekan penulisOrganisasiArtikel bersama
Nino RinaldiNational Research and Innovation Agency9
Isalmi AzizSyarif Hidayatullah State Islamic University Jakarta5
Joni PrasetyoNational Research and Innovation Agency4
Robert Ronal WidjayaNational Research and Innovation Agency4
Woro SumarniState University of Semarang3
SRI WAHYUNIHasanuddin University2
Sigit PriatmokoState University of Semarang2
Sri WahyuniState University of Semarang2
Anny SulaswattyIndonesian Institute of Sciences2
Siti NurbaytiSyarif Hidayatullah State Islamic University Jakarta2
Lisa AdhaniUniversitas Bhayangkara Jakarta Raya2
Sri Susilogati SumartiState University of Semarang1
Ramlawati RamlawatiState University of Makassar1
Endang SusilaningsihState University of Semarang1
Murbangun NuswowatiState University of Semarang1
Dyah Rini IndriyantiState University of Semarang1
Imas IstianiState University of Semarang1
Muzakki BashoriState University of Semarang1
Maria Ayu PuspitaAfiliasi tidak diketahui1
Novie Prasetyo UtomoAfiliasi tidak diketahui1
Muhammad JaeniAfiliasi tidak diketahui1
Ahmad BurhanudinAfiliasi tidak diketahui1
Eros Meiliana ShofaAfiliasi tidak diketahui1
Muhlisin MuhlisinAfiliasi tidak diketahui1
Ina AnggreaniAfiliasi tidak diketahui1
Woro SumarniState University of Semarang1
Fitri RahmawatiIndonesia University of Education1
Khaerur RifqiAfiliasi tidak diketahui1
Pertiwi Ayu Pamuji KurniatunAfiliasi tidak diketahui1
Harjito HarjitoAfiliasi tidak diketahui1
Lailatul BadriyahAfiliasi tidak diketahui1
Soeprodjo SoeprodjoAfiliasi tidak diketahui1
Luluk Amnah FitriyanaAfiliasi tidak diketahui1
Puji Eka RahayuAfiliasi tidak diketahui1
Harjono HarjonoState University of Semarang1
Samhasari Desthi MuslimahState University of Semarang1

Afiliasi berasal dari OpenAlex; metadata OAI-PMH jurnal tidak memuatnya. Penulis tanpa ID OpenAlex dicocokkan berdasarkan nama, sehingga dua orang bisa tergabung atau satu orang bisa terpisah.

Sumber metadata: OAI-PMH (metadata jurnal) https://ijred.cbiore.id/index.php/ijred/oai, pertama di-harvest 8 Nov 2026, terakhir terlihat 16 Nov 2026.
Metadata asli (oai_dc)
<oai_dc:dc xmlns="http://www.openarchives.org/OAI/2.0/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:oai_dc="http://www.openarchives.org/OAI/2.0/oai_dc/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.openarchives.org/OAI/2.0/oai_dc/  http://www.openarchives.org/OAI/2.0/oai_dc.xsd">
	<dc:title xml:lang="en-US">The effect of temperature during the hydrocracking of low-density polyethylene using a Ni-Cu/HZSM-5 catalyst</dc:title>
	<dc:creator>Maulida, Suhailah Salma</dc:creator>
	<dc:creator>Kadarwati, Sri</dc:creator>
	<dc:creator>Dwiatmoko, Adid Adep</dc:creator>
	<dc:creator>Agustian, Egi</dc:creator>
	<dc:subject xml:lang="en-US">LDPE plastics; catalytic hydrocracking; Ni-Cu/HZSM-5 catalyst</dc:subject>
	<dc:description xml:lang="en-US">LDPE plastics contributed 20-30% of the plastics use. Due to its non-biodegradable properties, plastic waste management is crucial. In the other hand, the LDPE plastics provide potential and benefits in the exploration of energy resources; they could be converted to liquid fuels through a catalytic hydrocracking. This study focuses on the effect of temperatures during the hydrocracking of LDPE using a Ni-Cu/HZSM-5 catalyst. The Ni-Cu/HZSM-5 catalyst was synthesized using the wet impregnation method assisted by an ultrasonic irradiation. The characteristics of the catalyst were evaluated prior to its use during the hydrocracking of LDPE. This study showed that the impregnation of Ni and Cu at HZSM-5 surface did not significantly affect the crystallinity of HZSM-5. Even though the peaks of Ni and Cu in the diffraction pattern were not clearly observed, their presence at HZSM-5 surface was well confirmed by the XRF spectrum. In addition, the hierarchical structure of HZSM-5 was also confirmed by the appearance of microporosity together with the type-IV hysteresis loop on the nitrogen adsorption-desorption isotherm. A considerable decrease (~25%) of the catalyst acidity was observed after the impregnation of Ni and Cu at HZSM-5 surface. The Ni-Cu/HZSM-5 catalyst showed a good activity during the hydrocracking of LDPE at temperatures of 275−400 °C, resulting in liquid, solid, and gaseous products. The yields of the liquid product increased by increasing the hydrocracking temperatures. It was observed that by increasing the hydrocracking temperatures, the yield of the kerosene and diesel fractions decreased, while the yield of the gasoline fraction increased, as supported by the density and calorific value that was close to the commercial gasoline. A further temperature increase would lead to more products with lighter fractions, reducing the yield of gasoline. This was also supported by the presence of alkenes, ketones, and esters formed after the catalytic hydrocracking as shown by the FTIR spectra of the liquid products.</dc:description>
	<dc:publisher xml:lang="en-US">Center of Biomass &amp; Renewable Energy (CBIORE)</dc:publisher>
	<dc:date>2026-07-02</dc:date>
	<dc:type>info:eu-repo/semantics/article</dc:type>
	<dc:type>info:eu-repo/semantics/publishedVersion</dc:type>
	<dc:type xml:lang="en-US"></dc:type>
	<dc:format>application/pdf</dc:format>
	<dc:identifier>https://ijred.cbiore.id/index.php/ijred/article/view/61922</dc:identifier>
	<dc:identifier>10.61435/ijred.2026.61922</dc:identifier>
	<dc:source xml:lang="en-US">International Journal of Renewable Energy Development; Vol 15, No 4 (2026): July 2026; 797-807</dc:source>
	<dc:source>2252-4940</dc:source>
	<dc:language>eng</dc:language>
	<dc:relation>https://ijred.cbiore.id/index.php/ijred/article/view/61922/pdf</dc:relation>
	<dc:rights xml:lang="en-US">Copyright (c) 2026 The Author(s). Published by Centre of Biomass and Renewable Energy (CBIORE)</dc:rights>
	<dc:rights xml:lang="en-US">https://creativecommons.org/licenses/by-sa/4.0</dc:rights>
</oai_dc:dc>